Are there any successes in this on going saga? Inquiring minds want to know.
Are there any successes in this on going saga? Inquiring minds want to know.
Not yet. Been waiting on revised code, but things are going forward in other areas. I've picked up some nice bucket seats and a console, and a pair of doors so I can get them prepped and painted-I have to go pick them up tomarrow.
haven't been able to look at this continually for more than about 5 minutes at a time before something else distracted me, but I believe I've found at least one significant reason why the issue of not updating MAP after baro updates stop occurs. I don't know why I decided to make code jumps where I did, but I have to scrap a good portion of the boost code that I had written.
That sucks. Hope a lot of it can be re-used, sounds like the code jumps may have worked you into a space corner?
I'm starting on sanding down the hood and doors this week, gonna try to get them prepped and ready to paint soon. Once I get the doors and hood painted and installed, it'll be ready to drive again. I can always just pull the bed off and put it on the work table while I fix it, and drive with no bed on the truck for a while. The frame could use a few good rainshower scrubbings to get all the dirt off!
Got the console and power bucket seats fitted, now just gotta finish the interior wiring-most of which I added myself when I picked up these power doors and seats.
Also got a nifty factory map-light rear-view mirror too, and it WORKS!
Hello. Please help i think i just bricked my ecm. I have 3.1 94 corsica with auto trans and 16196397 ecm. I flashed it many times to change idle rpm and other and everything was fine. But today i decided to disable EGR and changed min and max rpm using eex.xdf (with some comments) that i dowloaded earlier. After flashing completes cooling fan started as always and i turned ignition key off. After that when i turned the key to ign position my fan relay starts to click continuously and the car barely idles if i try to start it. I could not flash ecm because cats tuner says that it cant connect to ecm. I can read vehicle info and other info but cant reflash it with my old bin. Is there any way to reanimate my ecm or i neeed to buy new one?
You'll have to desolder the two flash PROMs and program them separately, then either resolder them or fit chip sockets And put the chips back in.
Unfortunately, $EE does not work with the 6397 ecm, you've flashed ab incompatible firmware.
Easy solution is eBay, I have bought perfectly fine PCMs on eBay for less than 10 bucks shipped.
Yeah i think i changed egr rpm using $EE xdf and it changed something else in my bin. I already ordered new ecu from ebay. Only problem is that i had to wait for it to ship to russia :D.
Bookmarks