Sometimes I'm more stupid than normal, but this is the case... I don't know what I know.

Using ADX: 217_OD_V217 for tunerpro. I want to see the Transmission Filter Temp (Pin B5). I added this item into values, with address 0x41, 65, 8 bit. I grounded out B5 to ground and no indication. Its not that simple I'm sure, because its suppose to be in the datastream so we can pluck it out... right?

I got the 0x41, 65 address from the trans1 ADX on tunerpro site.

Where did I go wrong and were do I need to go. I was going to use this to monitor oil temp and not have it modify the run as I am in a Corvair, so as long as it does not modify engine..... I'm good.

Ted Brown
Anderson, SC