Bringing TBI and Multi Port Fuel Injection to a New Level.     EFI Conversions and Tuning! Seattle to Portland! E-mail Tuning Consultant!
Results 1 to 5 of 5

Thread: Replacement for 1992 Dodge PCM

  1. #1
    Fuel Injected!
    Join Date
    Mar 2012
    Posts
    59

    Replacement for 1992 Dodge PCM

    I'm looking for suggestions for the best/easiest replacement for a 1992 Dodge Dakota PCM that I can tune & hopefully get a bit better mileage & efficiency out of. This is an underhood unit, & my idea is to make a conversion pigtail to go from the Dodge harness to the GM ECU.

    Doc

  2. #2
    Fuel Injected!
    Join Date
    Mar 2012
    Posts
    59
    I probably should have mentioned that the truck originally had a 5.2l/318, it now has a 5.9l/360 & will eventually get a stroked version that goes to about 408. It is running on the original 5.2l PCM right now & this seems to be fine as at that time the PCM in the 1500 trucks was the same between the 5.2l & 5.9l engines I just think that it should be able to do better, especially when running down the freeway empty. Like with lean cruise enabled...

  3. #3
    Super Moderator Six_Shooter's Avatar
    Join Date
    Feb 2011
    Posts
    2,845
    If your truck is like other Dodges I've come across, you may need to do something with the alternator as well. Some Dodges of that era (if not all) would trigger the alternator to charge from the ECM.
    The man who says something is impossible, is usually interrupted by the man doing it.

  4. #4
    Fuel Injected! JeepsAndGuns's Avatar
    Join Date
    Sep 2011
    Location
    alabama
    Age
    34
    Posts
    1,668
    I would probably say the 1227727 and run the code mask $8D. You will need to mod the distributor (or swap it out) to have/use a magnetic pickup. MAP sensor should work, as well as the IAC. TPS may need changed. CTS will need changed.
    I am doing a simillar swap to my 93 wrangler with a 4.0. They use almost the same chrylser underhood ecm.
    79 Jeep Cherokee, AMC 401, T-18 manual trans, hydroboost, 16197427 MPFI system---the toy

    93 Jeep YJ Wrangler, 4.0L, 5 speed, 8.8 rear, homebrew hub conversion and big brakes, hydroboost, 2.5in OME lift, 31x10.50's---the daily driver

    99 Jeep WJ Grand Cherokee limited, 4.0L, auto, 2wd, leather and power everything, 99% stock---the long distance highway ride.

  5. #5
    Fuel Injected!
    Join Date
    Mar 2012
    Posts
    59
    You are correct, Jeeps tend to be the same way, the voltage regulator is part of the PCM, but that is an easy enough fix, just slave in an external regulator. I had to do that as part of troublehooting an 98 Cherokee a couple years ago. I kept getting told that the trouble was in the voltage regulation, had the alternator tested by a reputable local shop, twice, and they swore it was good, slaved in the external voltage reg, same issue. finally I got under it while running & tested at the alt, initially good, then a few minutes later, nothing. I replaced the alt & all was good, pulled out the external voltage reg & spliced the wires back into the PCM, all still good. Anyway, the external vreg was all of like $22 I think, so that is a non issue...

Similar Threads

  1. Replies: 2
    Last Post: 04-27-2014, 04:48 PM
  2. possible 27SF512 chip replacement
    By 4153dodges in forum GM EFI Systems
    Replies: 7
    Last Post: 04-07-2014, 05:03 PM
  3. Still getting to know tunerpro. 1992 lt1 First data log
    By Leviathancj7 in forum TunerPro Tuning Talk
    Replies: 27
    Last Post: 09-28-2013, 03:43 PM
  4. SST27SF512 replacement.
    By Six_Shooter in forum Other EFI systems and related topics
    Replies: 9
    Last Post: 04-18-2013, 08:44 PM
  5. 1992-93 LT1 Thread
    By EagleMark in forum GM EFI Systems
    Replies: 1
    Last Post: 09-16-2011, 12:36 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •