wanting to learn more about the capabilites of tprtv5 .an having a reoccuring error code thought i would give this a try. i set this up as EagleMark described an was able to clear my error code .
nice sure beats disconnecting the battery.then i tryed to follow along with what Jp suggested
it took a minute to sink inTP now has the ability to send this command from a selection box at the top of the window.To do this from a "Send Command" box you must first edit the "Send" command and ensure the "Manually Sendable" box is checked.Then edit the "Macro" to also check the "Manually Sendable" box.Put a check mark in the "Break on Success" and Fail boxes.Otherwise TP will stop communicating because the command never ends.I am going to verify this works again once I put my motor back in (long story there!) Jp
" what send command box at the top of the window."
oh its not in the adx editor. its in the main task bar of tunerpro, .if you dont see it ,close the adx editor an click on view then click toolbars an check data acquisition send command then you will see it on the task bar.
Bookmarks