I was not looking forward to repining my stock wiring harness for the 427 PCM, so instead I made an adapter with the plug from my old ECM. If anyone sees a reason this won't work, let me know. The only question I have is in regards to Pins E14 (MAP Reference/5 volt Ref) and F14 (TP Reference/5 volt Ref) which according to the pin out spreadsheet both go to Pin C14. There aren't any notes about it and the chart with color codes shows pin C14 going to pin E14 only, it doesn't mention F14. I soldered both wires to pin C14, am I going to fry something by doing this?