Results 1 to 2 of 2

Thread: Disabling PE Mode in $4E

  1. #1
    Electronic Ignition!
    Join Date
    Oct 2014
    Age
    34
    Posts
    10

    Disabling PE Mode in $4E

    Can anyone help me out in choosing the best way to disable PE in $4E bin? There are only four parameters that deal with PE they are Power Enrichment Spark Adder, Power Enrich vs Baro, TPS for Power Enrich, AFR for Power Enrich. So rather me just playing around with each I would appreciate some direct advice on how to disable this so I can get back to tuning


    Thanks, Logan

  2. #2
    Super Moderator
    Join Date
    Mar 2011
    Location
    Camden, MI
    Age
    35
    Posts
    3,026
    running the TPS threshold up to its maximum will disable PE(or only enable it when TPS is calculated to be 100%, depending if the code does a comparison using "greater than" or "greater than or equal to").
    1995 Chevrolet Monte Carlo LS 3100 + 4T60E


Similar Threads

  1. In Learning Mode...
    By Speedking in forum Introductions
    Replies: 2
    Last Post: 12-09-2014, 11:58 PM
  2. '165 Not Going Into Diagnostic Mode
    By BurgerWorld in forum GM EFI Systems
    Replies: 5
    Last Post: 09-06-2013, 06:48 AM
  3. TPI in limp mode
    By Z1LE in forum GM EFI Systems
    Replies: 8
    Last Post: 04-23-2013, 11:33 PM
  4. Disabling Checksum
    By POZE in forum GM EFI Systems
    Replies: 7
    Last Post: 01-14-2013, 06:21 PM
  5. Mode 8 Silence
    By RobertISaar in forum TunerPro Tuning Talk
    Replies: 8
    Last Post: 02-23-2012, 12:49 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •