Hello all & thanks for the add. My name is Frank. I'm from southern ohio( bout as far south as you can go without hittin water)My current project is a 72 k5 blazer. I plan on swapping from carb to tbi.
Hello all & thanks for the add. My name is Frank. I'm from southern ohio( bout as far south as you can go without hittin water)My current project is a 72 k5 blazer. I plan on swapping from carb to tbi.
Thanks Dave. I just hope I don't sound too ignorant lol. My tbi swap consists of a setup out of a 94 c1500 350/4l60 e ecm 7427 & harness. I want to install this set up in my 72 k5 350/5 spd. What problems will I run into? I had a Holley projection(analog) setup on my old 69 c10 a couple years back,it was a definate improvement over the quadrajet, but had its problems also. I could never get it tuned quite right, but like I said it was still an improvement.
The '7427 TBI computer is an excellent computer! I strongly recommend using a Vehicle Speed Sensor (VSS) with the '7427! The original equipment 94 C1500 used a Digital Ration Adapter Controller (DRAC) or sometimes called a Vehicle Speed Sensor Buffer (VSSB) with a 40 pulses per drive shaft revolution VSS. The '7427 can be re-wired to accept a 2000 pulses per mile speedometer driven VSS, which will reduce cost and save some headaches.
dave w
Ok, I have a few questions....quite a few actually and am not sure where to go or who to ask. I need to know what all wires I can cut out of the harness. Also how or will the automatic trans control in the ecm affect the engine function or is it able to be deleted?
I apologize in advance for using Acronyms, you will need the following wires:
TPS
IAC
CTS
ESC
EST
KNK
INJ
VSS
MAP
Fuel Pump Control
ALDL
SES
Lots of information, including wiring diagrams on this link: http://www.gearhead-efi.com/Fuel-Inj...Information-0D
Program the PROM for manual transmission if you plan on using TH350 / TH400.
dave w
Bookmarks