Lean cruise and hpt 2 bar, anyone tried it?

**mecanicman** · 08-12-2014

Not sure why you think maf plays in but it works just fine in sd. All lean cruise is is a afr subtractor based on airflow vs rpm once you surpass the enabling speed. I have tested it blended, maf only, sd only and works fine . First hiccup was 2 bar os and becoming an adder after boost.

**Lextech** · 08-12-2014

I guess the point I was actually trying to make is - I'm not sure lean cruise is properly functional in a Custom Operating System.

**mecanicman** · 08-13-2014

You would appear to correct on that. Was hoping someone else had tried, maybe on someone with commodore experiance.

**MikeOD** · 11-12-2014

HPT can enable it...in a cable throttle vehicle. If you try to do it in a DBW vehicle, you seem to lose cruise control...I haven't figured that one out yet.

To enable it without the OS hack that EFILive does, just change the platform code to V, and move the data from your original platform code over to the V platform in the system options table under engine/system. After that, you need to setup the speed and time delay constants, the EQ ratio subtractor and multiplier, and leanout rate...and don't forget the AFR spark adder...compare to a Holden for an idea of what to do and then tune it from there.

I did this in my old F-Body (2000 Z28) running a 2002 12212156 OS. I eventually converted that car to the 1 bar enhanced SD OS because of a failed MAF sensor...I saw no need to replace it), and LC still worked fine. I never had any issues with operation of any features of the car with the platform changed to V.

I have not tried it combined with boost on a 2 or 3 bar OS though.

I tried the same thing in my 2005 Silverado (12592618 and DBW), and I immediately lost cruise control. Everything else worked, but no cruise control (it did lean cruise though). I wound up doing it with the OS hack in EFILive instead...but I'm not running an enhanced OS in that truck...just the original OS with a minor amount of tuning.

**mecanicman** · 11-12-2014

I enable lean cruise in .bin format before it goes into hpt. I have modified every o/s from 12212156 to the last p59 available in 2007 including some the efi live patch does not have. Works great. Only problem I have found is when used in conjunction with hpt cos. I want to do some more testing, but have not had access to a vehicle to play with while I had time to play.

**Fast355** · 11-13-2014

Originally Posted by mecanicman

I enable lean cruise in .bin format before it goes into hpt. I have modified every o/s from 12212156 to the last p59 available in 2007 including some the efi live patch does not have. Works great. Only problem I have found is when used in conjunction with hpt cos. I want to do some more testing, but have not had access to a vehicle to play with while I had time to play.

Are you able to change the VIN# in .BIN form??? Looking for a Lean Cruised version of the 12212156 O/S 2002 350 4L80E Express van calibration. My current setup lacks lean cruise and started life as a 4L60E calibration that has been segment swapped by HPT and simply does not feel right to me. That and I want a 6.0L 4L80E tune for the same VIN for my future EFI Connection 24x swap.