Enable data Tracing in TunerPro How To!

[EagleMark]

That's what we figured out. But if we had a scaler box open that was set up for data tracing that showed when idle was on or off! You would know what table your were in! Idle. Off Idle. Since they overlap. in $OD $OE

My $EE is extension tables, so I can see when it goes from one into the other. Bubble stays in top row of extension table while roaming around top, then when it enters bottom table and roams around, the bubble it top table stays in bottom row. So it does not matter.

[gregs78cam]

AFAIK there is no way to have the bubble jump from one table to another.

That is what i am thinking. I don't think that there is a way to turn the trace on or off dependant upon a bitmask.

[supercoop]

hey Mark , working with data tracing an history tables ran into an issue .
following along with the tutorials, got my main VE an spark tables set up.big thanks
thought i had done something, until i ran a log an realized. it wasnt reading correctly.
the main ve history would only populate in the 20 kpa column. an the blk bubble would only appear to
move up an down ,in 20 kpa column of the main ve table set up with data tracing.


doing some reading, found this formula , mentioned in another post. X * .369 + 10.354
but it didnt mention where to put it.
so i inserted it,
under Acquisition ,edit definition, values, MAP, click converision tab, Equation.
i replaced the following equation X * 0.019600 + 0.000000


with X * .369 + 10.354 an saved .


an now the tables appear to work correctly.

is this right?

rob

[EagleMark]

X * 0.019600 + 0.000000 is for MAP Volts.

X * .369 + 10.354 is for MAP kpa.

So you either choose the wrong MAP? Or your data ADX did not have MAP kpa? You can add another value and use all the same info, except name, unique ID and conversion and have 2 values from same data stream address.

Or even add a third for vacuum 29.9-(X*.349)

[supercoop]

yes i think it only has map volts .

in the adx editor ,i should change the map value back to original. then create a new map value with kilopascals
with this X * .369 + 10.354. ?

here are the files im using. if you would like review what ive done.
ecm 1227429 ARW

[EagleMark]

Well change it or add another. Should really add values and not subtract, you may want to know what MAP volts is one day.

Looks to be working fine in Spark and VE table.

[supercoop]

Good, i see now. i will work on it some more. thanks

[ony]

got the data traceing going with $ao, this thing is neat watching main spark table an history table at the same time, they match each other as to where they are on the scale. thanks eagle mark.

[gp90gta]

Was looking for something else and found this, I had no idea TP could do this, I tried it out and it work, very cool!