Here is the finished wheel the guy slotted it for me to lock in tdc as needed
Well I ran out of time to run the 0411 set up to make it for the local Flat bottom Boogie boat show. I decided to just run the mefi for now and way differnent in tuning any other ecms ive done. All bpw which I kinda knew but when I swapped to these 60lb injectors there was no flow rate parameters just the offset voltage which I changed. I trimmed back the BPW tables and got a startup. I found a write up on to integrate my LC1 into scanner pro to log my afr. Ill do this through the VSS signal since obviously I don't have a speedo.
https://youtu.be/_H44C6V7wJI
Ok I was not able to make the VSS log AFR but I got the boat dialed in and now I found an old draw through Gale banks set up. I will keep the EFI and draw through the TB. I also scored a MEFI4 ecm and harness from a fellow member. It was off an 8.1 with COP ignition so ive decided to run the MEFI instead of the 0411. I actually like the MEFI ecm for tuning not sure why they get bashed a lot.
Bookmarks