Help with Ostrich

[jay7199]

Im having problems getting ostrich to work, I think I may have the incorrect bin but im not sure.

So I can connect with tunerproRT and I can upload the bin/download.. verify but I cannot make a connection to the ECU with datamaster/ALDLDroid.

The web is really confusing as to what mask to use, iv spent hours searching around before I even attempted to use ostrich and settled on the $DA3 mask for my first attempt, ALDLDroid uses a $DA3.adx file that the creater made for me and was able to log the car with only a slight mathematics issue witch is why I started there, Well with Ostrich plugged in and the $DA3 bin I found on the web uploaded.. no luck!

So I tried a $DA2 setup.. same thing, cannot connect so I did not even try to start the car obviously.

I found a BAFL vette 5.7 LT1 6speed bin on the web and tried that with the same result..

The car is a 93 6 speed, Moates says to use $DA2.

So does anyone have a bin for a 93 6speed or have any other insight?

Thanks.

[EagleMark]

All the $DA files we have are here:
http://www.gearhead-efi.com/Fuel-Inj...mation-DA2-DA3

93 should use $DA3.

It sounds like you have two problems, one Ostrich and one ALDL Droid? Can you get the Ostrich working without ALDL Droid first, then try to hook it up while running.

[jay7199]

Before I attempted to start it I wanted to test communication with the ECU viva ALDLDroid or DataMaster to verify the bin uploaded ok and was the right file type, I could never get any communication so I never attempted to start the car.

Im using the BAFL vette 5.7LT1 6 speed.BIN from that thread because I believe its the most accurate one I have found, but two questions.. What does BAFL mean? and if that bin is for a 92, will it work on a 93?

Thanks.