trouble burning a chip

[bonnieclyde100]

i have tunerpro rt and moates autoprom and i am having trouble burning my first chip. when i upload bin to emulator it tells me that the bin is larger than emulation ram perhaps you meant to use bank 8. not sure what that means. any help would be great

[ony]

sounds like you need to set the off sets to 00f000, or 000f00 I really forgot which is correct.

[EagleMark]

Don't use the Emulator to burn chips.

In TunerPro RT go to Tools, Hardware Utilities, Moates PROM I/O and it's the same software from Moates Flash and Burn. Get the offsets correct.

http://www.gearhead-efi.com/Fuel-Inj...Flash-and-Burn

[bonnieclyde100]

if the file i am loading to buffer is the bin file when i do it it just says fil larger than chip selected. its not giving me any size. i even erased the chip and tried again with no luck. should i try each address until i find the rite one? the chip is the ones that came with the autoprom 27sf512

Don't use the Emulator to burn chips.

In TunerPro RT go to Tools, Hardware Utilities, Moates PROM I/O and it's the same software from Moates Flash and Burn. Get the offsets correct.

http://www.gearhead-efi.com/Fuel-Inj...Flash-and-Burn

[EagleMark]

What size is your bin file?

Did you select the 27FS512 chip? Then double check both sets of offsets are correct?

Match it up to the list I made at link above for offsets.

[bonnieclyde100]

apparently the program didnt like the changed and renamed file i had because when i loaded the original file it did it and gave me the byte size 65536

What size is your bin file?

Did you select the 27FS512 chip? Then double check both sets of offsets are correct?

Match it up to the list I made at link above for offsets.

[bonnieclyde100]

the chip took the program but i wont know until later if it worked or not. when i make changes to the bin like transmission and error code changes do i put them on the chip the same wayor can i use the upload arrows?

What size is your bin file?

Did you select the 27FS512 chip? Then double check both sets of offsets are correct?

Match it up to the list I made at link above for offsets.

[EagleMark]

Here's the offsets with program set to 27FS512
64k (65536) 27SF512 000000 -> 00FFFF 000000 -> 00FFFF

If it accepted it, it should be fine, you'll know when you install chip and watch CEL for on, blink and stay on till engine starts then off.

You always open the bin in TunerPro RT with correct XDF, make changes, save file with new name. Then do the erase and burn process again.

[bonnieclyde100]

i redid my changes and saved file again and this time it took my changed file thanks for the help. it will probably be next weekend before i can try it if the weather is ok.

Here's the offsets with program set to 27FS512
64k (65536) 27SF512 000000 -> 00FFFF 000000 -> 00FFFF

If it accepted it, it should be fine, you'll know when you install chip and watch CEL for on, blink and stay on till engine starts then off.

You always open the bin in TunerPro RT with correct XDF, make changes, save file with new name. Then do the erase and burn process again.