Quote Originally Posted by lionelhutz View Post
All good bearing manufacturers publish this fact in their failure analysis documents.
Quote Originally Posted by CDeeZ View Post
The factory (Tremec) endplay specs for the T56 is .000" to .002" endplay on the mainshaft, .000" to .002" preload on the countershaft, and .000" to .002" endplay on the countershaft extension.


And this is to both of those statements listed above..... And?????? So what???????? Don't take this personal and go ape shit again I'm just saying. I do what works for me. I don't care much about what is written down somewhere or stated. I will investigate it, consider, and ultimately it is still MY decision to make. So what's wrong with having some autonomy in the matter and doing something independent of what is stated or published by someone else? ALL OF THESE QUESTIONS ARE RHETORICAL. Don't freak out.