Lean cruise AFR ratios wont save?

[BrandonA.]

Hello the good news is I got the Highway lean cruise mode to work today and can see it come on with my wideband LM-1. Bad news is I can't adjust the AFR chart for highway mode and save it and burn it. I can only use the settings you originally entered. THis is what I am experiencing.

1. When I change the AFR in the chart I hit the save icon and it saves them in the chart. Once that is done if I go to the (Patches) and check the (HIWay lean cruise Esc patch) and it says "Indeterminate data does not match" so therefore HIway mode will not engage without this patch installed.


2.So if I re-install the patch it changes all the Air fuel numbers back to your settings. So basically I can't adjust them and use my own AFR ratio settings without loosing the (HIWay lean cruise Esc patch).


3. What am I doing wrong? ANy ideas? THanks I really want to use it as I am so close!!!!!


Brandon

[BrandonA.]

-On a hunch I tried (Save bin as) instead of (save bin) and it still won't let me keep my new AFR settings that I would like to try. I am officially lost on this one can anybody tell me what I might be doing wrong??????


Heeeelllllpppppp!!!!

Brandon!!!!!

[EagleMark]

Apply the patch first. Then reopen the patch and it will say "Patched" Poof your done and leave it alone. Then adjust all Highway Lean Cruise Options.

If you checked the patch again after making changes it will say "Indeterminate: data does not match." because you have changed it from original.

[BrandonA.]

Thanks eagle mark it seemed whenever I had "Indeterminate: data does not match." and tried the chip it did not engage lean cruise mode. Maybe I missed something else. But it worked when I left it alone and used your settings. Maybe this message was not the problem then..... I will try again..

Thanks for the help!!

Brandon

[EagleMark]

You can remove patch to reset, when you re-open the patch it will say Not Patched. Then apply, if re-opened it will say patched. Then if you change any setting in HLC and re-open the patch it will say "Indeterminate: data does not match."

Make sure when patched all qualifiers are set properly, then AFR table and Spark table. It should look like this patched.

[BrandonA.]

Hello Mark, I went through all the steps again and made sure everything was set correctly for engaging highway mode. It still wont work and the only difference I can find is it says "Indeterminate: data does not match." vs. the one that actually works with your original settings. I realize you said that is normal once adjusting the settings, but it still won't work after verifying what you told me to double check. I am going to try and send you my bin to see what is wrong....... Hopefully this will clear some things up....


Thanks,
Brandon