what im missing here

[ony]

if I can find it I got a awdn bin that I ran for a long time that was a really good bin iam interested how you turn out because I want to put a little better cam in my v6 when I overhaul or rebuild it.

[rytari]

here is log file with my own bin.

[ony]

rytari ,I looked at your data log an you need to run the engine till it gets to operating tempeture before you will see closed loop idle. your idle will probly drop 150-200 rpms when it goes closed loop then take it a drive then get 1-5 minutes idling if you are comfortable with it idleing that long. if your engine has not bin broke in yet I would drive it at 2000-3000 rpms for a 1/2 hour or so before you do a lot of idleing.get you another data log and post the bin you want to change.

[rytari]

i drove almost full hour for that log and it shows only a minute or so... weird...

[ony]

my be a bad usb cable, I seen it stop when I was playing yor log and thought it might be on my end, I don't remember the 747 going to 6400 rpms in some of the tables. I would down load the latest adx xdl file from this sight for the 747 and see if the log file changes.my adx or xdl file for logging does go to 6400 rpms, I geuss I forgot .I was thinking about when you open a bin file, timming table tops out at 3200 . my setup sometimes stops an starts,if I restart tuner pro and reconnect my cable it stays on the whole data log.

[rytari]

here is idling and driving... li it shows blm are almost constantly 108 but still my afr gauge shows 10.3 to 12.5 when iding and 15.0-17.3 when driving rmp under 1200

[ony]

need to adjust the ve table and check to see if it stays closed loop at idle after you adjust it. the int is trying to lean it out if your blm is close to 128 it will change a lot. if you post a bin I will change it .