Results 1 to 2 of 2

Thread: Hi, I am newbie looking to program a chip for a 1227703 ECM

  1. #1
    Electronic Ignition!
    Join Date
    Sep 2013
    Age
    34
    Posts
    12

    Hi, I am newbie looking to program a chip for a 1227703 ECM

    I just purchased a GQ-4X programmer to program a chip for an 1227703 ECM . The chip used is in a socket which is soldered onto the Mainboard. The chip has only 24 pins. What chip would I need, and is there soem sort of adapter available to plug the new programed chip into the mother board. I also would like to be able the read the data of the "old" chip. Any help is greatly appreciated.

    The entire project is part of the installation of a GM 2.8 V6 into a MGB.


    Cheers

  2. #2
    Super Moderator Six_Shooter's Avatar
    Join Date
    Feb 2011
    Posts
    2,968
    I don't seem to be able to locate much information on that ECM, other than it's from an '86 2.8L.

    You will probably want to use a newer ECM, that is more supported if you want to get into modifying the bin file (tune) within the ECM.
    The man who says something is impossible, is usually interrupted by the man doing it.

Similar Threads

  1. Replies: 58
    Last Post: 08-07-2013, 09:20 PM
  2. AN28F512 FLash - Program Request - fboot.exe
    By dan_t in forum GM EFI Systems
    Replies: 0
    Last Post: 05-06-2013, 08:45 PM
  3. Replies: 1
    Last Post: 04-13-2013, 06:49 PM
  4. Chip Offsets stock chip?
    By POZE in forum GM EFI Systems
    Replies: 14
    Last Post: 01-28-2013, 02:06 AM
  5. 27sf512 chip mod for 24 pin?
    By jameslleary in forum GM EFI Systems
    Replies: 17
    Last Post: 06-03-2012, 09:52 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •