My Laptop crashed and I had to get a new one and install tunerpro onto it. Currently using $42 on a TBI setup. I am using a moates burn2 to read my chip that was my current tune so that I can work with it some more. However it does not seem to be working correctly. After reading the chip, verifying it against the buffer, then saving it to the laptop, for example when I open up the timing table it says every block is set to 89.5 degrees. Now I know that is not right. If I open up a previous file that I had saved on a flash drive though, everything looks normal. so where have I gone wrong here?
Thanks
Roy