newbie problem

[brad454]

Hi
I have a 1990 r2500 burb with the 7.4. Here is the problem I am facing. I tried the $42 file series. The analog gauges are unreadable. The needles move, so I believe the data stream is flowing. The digital number underneath work. Do I need another set of files or is there another problem? Would the $85 file work?

Thanks Brad

[EagleMark]

What is the ECM number? While you look get the four letter BCC/chip code...

[brad454]

Ok here is the numbers I came up with;

On the ECM - 01228747

On the chip I found these:

JT8(G)/J6/P
LFIVN812
AD40

[EagleMark]

1228747 is $4F
http://www.gearhead-efi.com/Fuel-Inj...Information-4F

For the chip you need the four letters off top of chip. The numbers you gave are off the bottom and don't help.

[brad454]

Sorry about that. I had the chip in a holder. It is AUMZ
Now with tunerpro running, but not hooked up to the vehicle, should the gauges be readable with the new ($4F) file?
Thanks Brad

[EagleMark]

Not without a data log to tell them what to read.

Or do you mean they are blank? If they are blank it's because I add a butt load of pre made dashboards to ADX files I work on, but you need to Right Click on each gauge and choose from the list what you want there.

[brad454]

No what I mean is that the gauges are unreadable. Say for instance rpms. The needle is pointing to a scratch instead of a number.

[Six_Shooter]

I think a screen shot is needed to understand the problem.

[brad454]

The laptop is outside out of range of the hotspot. Let me get a screenshot and I will post it up in a while.
Thank you for your assistance. It is much appreciated.
Brad

[brad454]

Here is the screen shot after I used 4F. The truck wasn't hooked up. Is it supposed to be like that?

Thanks Brad

tunerpro.jpg

[EagleMark]

Ahhhhhhh.....???? Something is wrong? I just checked and those ADX work fine, I actually used them a couple weeks ago on a truck too... but it's like your computer is missing fonts? or?

[brad454]

I wonder what is wrong!!! I used this laptop before with TP and didn't have a problem. I will check into it.
Thanks again for all your assistance
I will let you know what the problem was if I figure it out.
Brad