Results 1 to 15 of 55

Thread: Coil per cylinder 4.3?

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Fuel Injected!
    Join Date
    May 2013
    Posts
    174
    thoughts?

    I looked at which injector pins went to what cylinders between the two pinouts, and then match the coils.



    blue 2002 S-10 4.3 Typical V8 0411 Coil per cylinder 4.3?
    1 ground ground ground
    2 12v ref 12V reference 12v ref
    3 - Fuel injector #3 -
    4 Fuel injector #4 Fuel injector #2 Fuel injector #4
    5 - - -
    6 - - -
    7 - - -
    8 5v ref - 5v ref
    9 Knock sensor signal - Knock sensor signal
    10 - - -
    11 - KS #2 signal -
    12 Crank pos signal Crank position signal Crank pos signal
    13 - Requested torque signal -
    14 - UART serial data secondary -
    15 - UART serial data tertiary -
    16 - - -
    17 Trans fluid pressure switch signal B Trans fluid pressure switch signal B Trans fluid pressure switch signal B
    18 Trans fluid pressure switch signal C Trans fluid pressure switch signal C Trans fluid pressure switch signal C
    19 IGN+ IGN+ IGN+
    20 B+ B+ B+
    21 Low ref Low ref Low ref
    22 - - -
    23 Low ref Low ref Low ref
    24 - - -
    25 HO2S low bank2 sensor 1 HO2S low bank2 sensor 1 HO2S low bank2 sensor 1
    26 HO2S low bank2 sensor 2 HO2S low bank2 sensor 2 HO2S low bank2 sensor 2
    27 - - -
    28 HO2S low signal bank 1 sensor 2 HO2S low signal bank 1 sensor 2 HO2S low signal bank 1 sensor 2
    29 HO2S low signal bank 1 sensor 1 HO2S low signal bank 1 sensor 1 HO2S low signal bank 1 sensor 1
    30 Coolant level switch signal Coolant level switch signal Coolant level switch signal
    31 - - -
    32 Transmission range signal A Transmission range signal A Transmission range signal A
    33 TCC brake switch signal TCC brake switch signal TCC brake switch signal
    34 Transmission range switch signal P Transmission range switch signal P Transmission range switch signal P
    35 CPP switch signal CPP switch signal CPP switch signal
    36 Fuel injector #1 Fuel injector #1 Fuel injector #1
    37 Fuel injector #3 Fuel injector #6 Fuel injector #3
    38 - Damping lift/dive signal -
    39 - - -
    40 ground ground ground
    41 - Low ref -
    42 - - -
    43 Fuel injector #5 Fuel injector #7 Fuel injector #5
    44 - Fuel injector #5 -
    45 - FTP 5V ref -
    46 5v ref TPS 5V ref 5v ref
    47 - MAP 5V ref -
    48 5v ref EGR 5V ref 5v ref
    49 Low ref - Low ref
    50 - - -
    51 - KS bank 1 signal -
    52 - - -
    53 Low ref (RPO M30 only) Low reference Low ref (RPO M30 only)
    54 Low ref Low reference Low ref
    55 - EGR valve position signal -
    56 - - -
    57 B+ B+ B+
    58 Class II serial Class II serial Class II serial
    59 Class II serial Class II serial Class II serial
    60 Low ref Low ref Low ref
    61 Low ref Low ref Low ref
    62 - - -
    63 HO2S low ref Low ref HO2S low ref
    64 - - -
    65 - HO2S high signal bank 2 sensor 2 -
    66 HO2S High signal HO2S high signal bank 2 sensor 1 HO2S High signal
    67 - - -
    68 HO2S high signal HO2S high signal bank 1 sensor 2 HO2S high signal
    69 HO2S high signal HO2S high signal bank 1 sensor 1 HO2S high signal
    70 - Oil level switch -
    71 - - -
    72 Trans range switch signal B Trans range switch signal B Trans range switch signal B
    73 Cam position signal Cam position signal Cam position signal
    74 ECT signal ECT signal ECT signal
    75 B+(RPO M30 only) B+ B+(RPO M30 only)
    76 Fuel injector #3 Fuel injector #5 Fuel injector #3
    77 Fuel injector #6 Fuel injector #8 Fuel injector #6
    78 - - -
    79 3-2 shift solenoid control 3-2 shift solenoid control 3-2 shift solenoid control
    80 Low ref Low ref Low ref




    Red 2002 S-10 4.3 Typical V8 0411 2002 S-10 4.3
    1 Ground Ground Ground
    2 TCC PWM solenoid control TCC PWM solenoid control TCC PWM solenoid control
    3 - Secondary fuel pump relay control -
    4 - - -
    5 - Delivered torque signal -
    6 PC solenoid high control (A) PC solenoid high control (A) PC solenoid high control (A)
    7 - EGR supply voltage -
    8 PC solenoid low control(A) PC solenoid low control(A) PC solenoid low control(A)
    9 Primary fuel pump relay control Primary fuel pump relay control Primary fuel pump relay control
    10 Engine speed signal Engine speed signal Engine speed signal
    11 - AC high pressure recirc switch signal -
    12 - - -
    13 Cruise status Cruise status Cruise status
    14 - - -
    15 Generator turn on signal Charge indicator control Generator turn on signal
    16 4wd low signal 4wd low signal 4wd low signal
    17 AC request AC request AC request
    18 - - -
    19 Axle switch signal Axle switch signal Axle switch signal
    20 VSS low VSS low VSS low
    21 VSS high VSS high VSS high
    22 - ISS high -
    23 - ISS low -
    24 TPS signal - TPS signal
    25 IAT signal IAT signal IAT signal
    26 IC timing signal Coil 1 control Coil 1 control
    27 - Coil 7 control Coil 5 control
    28 -- Coil 6 control Coil 3 control
    29 - Coil 4 control Coil 2 control
    30 - - -
    31 MAF signal MAF signal MAF signal
    32 MAP signal MAP signal MAP signal
    33 - Recirc actuator control -
    34 EVAP purge control EVAP purge control EVAP purge control
    35 - - -
    36 - AIR pump relay -
    37 - - -
    38 - - -
    39 12V ref 12V ref 12V ref
    40 ground ground ground
    41 - EGR solenoid control -
    42 TCC solenoid control TCC solenoid control TCC solenoid control
    43 AC relay control AC relay control AC relay control
    44 - - -
    45 EVAP vent control EVAP vent control EVAP vent control
    46 SES light SES light SES light
    47 2-3 shift solenoid 2-3 shift solenoid 2-3 shift solenoid
    48 1-2 shift solenoid 1-2 shift solenoid 1-2 shift solenoid
    49 Vehicle speed signal Vehicle speed signal Vehicle speed signal
    50 VSS signal VSS signal VSS signal
    51 Trans fluid temp signal Trans fluid temp signal Trans fluid temp signal
    52 Generator field duty cycle signal Generator field duty cycle signal Generator field duty cycle signal
    53 - - -
    54 Low ref Fuel level signal(primary) Low ref
    55 AC low pressure switch signal AC low pressure switch signal AC low pressure switch signal
    56 - - -
    57 Low ref Low ref Low ref
    58 - - -
    59 - - -
    60 - Low ref -
    61 - Low ref -
    62 Trans range switch signal C Trans range switch signal C Trans range switch signal C
    63 Trans pressure switch signal A Trans pressure switch signal A Trans pressure switch signal A
    64 STP pressure signal STP pressure signal STP pressure signal
    65 - - -
    66 - Coil 8 control Coil 6 control
    67 - Coil 2 control -
    68 - Coil 5 control Coil 3 control
    69 - Coil 3 control -
    70 - - -
    71 - - -
    72 HO2S heater low control bank 2 sensor 1 HO2S heater low control bank 2 sensor 1 HO2S heater low control bank 2 sensor 1
    73 - Fuel level signal (secondary) -
    74 HO2S heater high control bank 2 sensor 1 HO2S heater high control bank 2 sensor 1 HO2S heater high control bank 2 sensor 1
    75 - - -
    76 IAC coil B high control IAC coil B high control IAC coil B high control
    77 IAC coil B low control IAC coil B low control IAC coil B low control
    78 IAC coil A low control IAC coil A low control IAC coil A low control
    79 IAC coil A high control IAC coil A high control IAC coil A high control
    80 HO2S heater low ref Low ref HO2S heater low ref
    Last edited by ericjon262; 08-10-2013 at 03:29 AM.

  2. #2
    RIP EagleMark's Avatar
    Join Date
    Feb 2011
    Location
    North Idaho
    Age
    64
    Posts
    10,477
    Sure looks like a good start! My concern would be the code, not sure the vehicle platform change is going to work? This is new ground. Would be nice to have a test bench for this but then again you'll have a test bench when installed in the truck...

    1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
    1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
    -= =-

  3. #3
    Fuel Injected!
    Join Date
    May 2013
    Posts
    174
    Quote Originally Posted by EagleMark View Post
    Sure looks like a good start! My concern would be the code, not sure the vehicle platform change is going to work? This is new ground. Would be nice to have a test bench for this but then again you'll have a test bench when installed in the truck...
    I need a text bench bad... once I have a shop again, it'll be on my to do list. among many other things.

    FWIW, this won't necessarily be a truck, like all the other mix match parts I own, this would be going into the Fiero.

Similar Threads

  1. Need ideas for 4 cylinder DIS underhood ECM project?
    By EagleMark in forum GM EFI Systems
    Replies: 23
    Last Post: 08-23-2017, 07:10 AM
  2. Will ASDZ BIN run a four cylinder?
    By POZE in forum GM EFI Systems
    Replies: 1
    Last Post: 02-26-2013, 08:20 PM
  3. Cylinder select error
    By JeepsAndGuns in forum GM EFI Systems
    Replies: 35
    Last Post: 08-06-2012, 02:19 AM
  4. Best BIN for runing 1.5 L 4 cylinder
    By POZE in forum GM EFI Systems
    Replies: 33
    Last Post: 03-21-2012, 08:10 PM
  5. Cylinder select error
    By Mean LT1 in forum GM EFI Systems
    Replies: 4
    Last Post: 02-15-2012, 10:19 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •