So I'm about ready to get started on this.
Truck has a stock 73 350 truck motor in it, stock exhaust manifolds.

Partts I have:
91ish 350 tbi with sensors and injectors
92 car tbi intake manifold, with the wedges to use for my old heads.
89 van 7747 ecm, 350 auto
94 truck tbi harness, 2wd 4l60e tranny
Couple of rolls of 5/16 tubing for fuel lines.
88 corvetter distributor, module, cap, rotor, etc
Unknown vette knock sensor filter
92 water temp sensor
Still need (correct me if I'm wrong)
Vss signal generator for mechanical speedo
O2 sensor
Knock sensor
Fuel pump

So, anything I'm missing?
Can I make my piles of spares work together?
Truck will be going 700r4 auto with mechanical speedo output. Already have truck serpentine conversion.
Any reason I should hold out to find a 94ecm?

Most of these parts fell in my lap. I have less than a hundred bucks in the whole pile.
Any reccomendations on what I can do for a cheap fuel pump? I was thinking of using a leftover holley blue carb pump, but I don't think it will flow enough.

Michael