hi was checking my data and noticed that the trans shows no data info should there be ???94 roadmaster
hi was checking my data and noticed that the trans shows no data info should there be ???94 roadmaster
It only gets engine or trans.
For trans data open TP and look up top for the 2 gears Icon, or Aqcuistion Edit Definition, when the window come open change Engine Connection to Trans Connection and Engine Data to Trans Data. Save and connect when engine is running.
1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
-= =-
will it save both at same time or will I have to do 2sep runs for eng then another for trans thanks
Really? I still have a headache from getting them to work separatly...
1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
-= =-
If you are using TPV5, you can change the datastream to include anything you want, you just have to set up the .bin for it, which is also much easier if you set up the .xdf for changing the commanded datastream. It is easier to change some of the engine data to trans data, as long as you know the address of the data you want.
http://www.gearhead-efi.com/Fuel-Inj...the-DataStream
The referenced objective was probably a much harder one to properly figure out, than what you want to change.
Last edited by gregs78cam; 05-12-2013 at 02:44 AM.
1978 Camaro Type LT, 383, Dual TBI, '7427, 4L80E
1981 Camaro Z-28 Clone, T-Tops, 350/TH350
1981 Camaro Berlinetta, V-6, 3spd
1974 Chevy/GMC Truck, '90 TBI 350, '7427, TH350, NP203, 6" lift, 35s
Hi everyone - I have learned a lot reading these forums, and want to thank you all for sharing your knowledge. I know this thread is a couple months old, but it seemed the most appropriate for my question.
I have 16188051 ECM/PCM, am running Tunerpro RT v5, with the EE.xdf and EE_Auto.adx files from the tunerpro website. I am having transmission problems, and was hoping to see tranny data. I hope screenshots come through, but I don't see where in my editor to change from engine to trans data:
editor.jpg
Here's a snapshot of my logfile - throughout my whole drive, all of my trans data stayed at "0". What's my best/easiest approach to see this data?
logfile snip.jpg
Thanks in advance for any help.
Last edited by 94z28vert; 07-14-2013 at 04:02 PM. Reason: snapshots didn't show up
I don't beleive it is in the files on TunerPRo site, although I gave them the files they were never posted. Look here for XDF and ADX.
http://www.gearhead-efi.com/Fuel-Inj...rmation-EE-EEB
Better yet here's the latest ones I've been working on.
1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
-= =-
Very much appreciated, EagleMark! I can't wait to take it out for a drive today and see it working. But just even from loading your adx & xdf files, then running my log file through it - looked much more intuitive! Thanks!
Bookmarks