does tuner pro rt do trans info?

[swat455]

hi was checking my data and noticed that the trans shows no data info should there be ???94 roadmaster

[EagleMark]

It only gets engine or trans.

For trans data open TP and look up top for the 2 gears Icon, or Aqcuistion Edit Definition, when the window come open change Engine Connection to Trans Connection and Engine Data to Trans Data. Save and connect when engine is running.

[swat455]

will it save both at same time or will I have to do 2sep runs for eng then another for trans thanks

[RobertISaar]

could setup the monitor command to grab data from both, but it will slow down logging rate.

[EagleMark]

Really? I still have a headache from getting them to work separatly...

[gregs78cam]

If you are using TPV5, you can change the datastream to include anything you want, you just have to set up the .bin for it, which is also much easier if you set up the .xdf for changing the commanded datastream. It is easier to change some of the engine data to trans data, as long as you know the address of the data you want.

http://www.gearhead-efi.com/Fuel-Inj...the-DataStream

The referenced objective was probably a much harder one to properly figure out, than what you want to change.

[94z28vert]

Hi everyone - I have learned a lot reading these forums, and want to thank you all for sharing your knowledge. I know this thread is a couple months old, but it seemed the most appropriate for my question.

I have 16188051 ECM/PCM, am running Tunerpro RT v5, with the EE.xdf and EE_Auto.adx files from the tunerpro website. I am having transmission problems, and was hoping to see tranny data. I hope screenshots come through, but I don't see where in my editor to change from engine to trans data:

editor.jpg

Here's a snapshot of my logfile - throughout my whole drive, all of my trans data stayed at "0". What's my best/easiest approach to see this data?

logfile snip.jpg

Thanks in advance for any help.

[EagleMark]

I don't beleive it is in the files on TunerPRo site, although I gave them the files they were never posted. Look here for XDF and ADX.
http://www.gearhead-efi.com/Fuel-Inj...rmation-EE-EEB

Better yet here's the latest ones I've been working on.

[94z28vert]

Very much appreciated, EagleMark! I can't wait to take it out for a drive today and see it working. But just even from loading your adx & xdf files, then running my log file through it - looked much more intuitive! Thanks!