Page 1 of 6 123456 LastLast
Results 1 to 15 of 77

Thread: NEEDED: 16197427 5.7L Manual Trans bin

  1. #1
    RIP EagleMark's Avatar
    Join Date
    Feb 2011
    Location
    North Idaho
    Age
    63
    Posts
    10,477

    NEEDED: 16197427 5.7L Manual Trans bin

    Anyone have a clean stock 5.7L bin for a 427 ECM conversion?

    1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
    1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
    -= =-

  2. #2
    Super Moderator
    Join Date
    Mar 2011
    Location
    Camden, MI
    Age
    35
    Posts
    3,026

    Re: NEEDED: 16197427 5.7L Manual Trans bin

    i don't believe you'll find a "stock" BIN..... IIRC, with the manual trans models, GM was still using an older ECM.
    1995 Chevrolet Monte Carlo LS 3100 + 4T60E


  3. #3
    RIP EagleMark's Avatar
    Join Date
    Feb 2011
    Location
    North Idaho
    Age
    63
    Posts
    10,477

    Re: NEEDED: 16197427 5.7L Manual Trans bin

    Yeah that's what everyone thought and would make sense then a manual bin file popped up! Man I wish I remember where...

    1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
    1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
    -= =-

  4. #4
    RIP EagleMark's Avatar
    Join Date
    Feb 2011
    Location
    North Idaho
    Age
    63
    Posts
    10,477

    Re: NEEDED: 16197427 5.7L Manual Trans bin

    But if I can't find one do you think I could just zero out all tranny paremeters in a auto bin file?

    1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
    1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
    -= =-

  5. #5
    Super Moderator
    Join Date
    Mar 2011
    Location
    Camden, MI
    Age
    35
    Posts
    3,026

    Re: NEEDED: 16197427 5.7L Manual Trans bin

    knowing GM, there's a code switch that would take care of that, but you would need to adjust other things, mostly IAC related.
    1995 Chevrolet Monte Carlo LS 3100 + 4T60E


  6. #6
    Fuel Injected!
    Join Date
    May 2011
    Location
    Pocono's PA.
    Age
    50
    Posts
    370

    Re: NEEDED: 16197427 5.7L Manual Trans bin

    I would be interested in a '7427 manual .bin as well if it is found.

    I started with BJYL, which is a 5.7/700R4 .bin, for my S10 434/Tremec project , worked out O.K but still "idle hunts" from time to time.

    TOM
    1994 3500 Dually , 502 (509) , 264HR , Edelbrock MPFI , PFI '7427
    1992 S-10 434 SBC/Tremec - '7427
    1986 Monte Carlo SS
    1984 S-10 , SAS, 496/700R4/205 , D44/14BFF -'7427
    1980 Z-28 496/700R4
    1979 Corvette 496/700R4
    1977 Olds 98 Regency 403/700R4

  7. #7
    RIP EagleMark's Avatar
    Join Date
    Feb 2011
    Location
    North Idaho
    Age
    63
    Posts
    10,477

    Re: NEEDED: 16197427 5.7L Manual Trans bin

    93V8S10 on TGO said he found some manuals at Moates but no V8 ones?

    So it looks like maybe the export BCC to start and import some 5.7L paremeters.

    BHFM, $0D, 1994, S1, PFI 2.2L L4(CAL), Manual, 8505
    BHRD, $0D, 1994, L1, CPI 4.3L V6(FED, ALT), Manual, 6395
    BNBJ, $0D, 1995, L1, CPI 4.3L V6(EXP), Manual, 7427

    1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
    1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
    -= =-

  8. #8
    RIP EagleMark's Avatar
    Join Date
    Feb 2011
    Location
    North Idaho
    Age
    63
    Posts
    10,477

    Re: NEEDED: 16197427 5.7L Manual Trans bin

    16196396 ECM
    C/K 1500,2500 - BDUY, BDUZ
    C/K 2500,3500 - BDTR

    and BHNB or BHNC are supposed to be 427 BCC manual trans for CAL because they needed the EGR pintle...

    1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
    1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
    -= =-

  9. #9
    Fuel Injected! gregs78cam's Avatar
    Join Date
    May 2011
    Location
    N. Idaho
    Posts
    767

    Re: NEEDED: 16197427 5.7L Manual Trans bin

    I would just start with any $0D bin that looks close and change the flags for TCC, shift light, Electronic shifting, and what not. I guess there are also some idle paramters used only for Manual Transmissions in the Advanced_$0D_TP5_v250.xdf. That '7427 is one very versatile PCM. I am getting a pretty good handle on this tunin' stuff, let me know when you plan to start tweaking it and I could probably find some time to come by and help.
    1978 Camaro Type LT, 383, Dual TBI, '7427, 4L80E
    1981 Camaro Z-28 Clone, T-Tops, 350/TH350
    1981 Camaro Berlinetta, V-6, 3spd
    1974 Chevy/GMC Truck, '90 TBI 350, '7427, TH350, NP203, 6" lift, 35s

  10. #10
    Super Moderator dave w's Avatar
    Join Date
    Feb 2011
    Posts
    6,268

    Re: NEEDED: 16197427 5.7L Manual Trans bin

    The 7.4 liter $OE BHDC bin file is manual transmission.

    dave w

  11. #11
    RIP EagleMark's Avatar
    Join Date
    Feb 2011
    Location
    North Idaho
    Age
    63
    Posts
    10,477

    Re: NEEDED: 16197427 5.7L Manual Trans bin

    Since it is going to need a full tune anyway I was just trying to find as close a match as possable to start. It's going on my sons 5.6L IH Engine we are rebuilding now, bottom end almost done.

    I think I will take both your advices and see what works best. I know that manual trans bins and engines before bins that had toilet bowels, ah I mean controlled fuel leaks/carburators had some form of decel valve as to not let throttle snap shut between shifts. This is why I wanted to start with a manual bin.

    From looking at defs made for this ECM/PCM the $OD does look like the most advanced but I did not see any paremeters for the manual shift decel valve situation, is another reason I wanted to start with a manual bin file. Sure lots of auto tranny choices and ons and offs, but no maual decel stuff... it may be there and work fine, all it does is slow the rate of decent of RPM between shifts. I beleive this was first installed as a emmissions device but ended up being a advantage to driving a manual trans.

    1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
    1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
    -= =-

  12. #12
    Super Moderator
    Join Date
    Mar 2011
    Location
    Camden, MI
    Age
    35
    Posts
    3,026

    Re: NEEDED: 16197427 5.7L Manual Trans bin

    i would think the IAC throttle follower would perform that function.
    1995 Chevrolet Monte Carlo LS 3100 + 4T60E


  13. #13
    Fuel Injected! gregs78cam's Avatar
    Join Date
    May 2011
    Location
    N. Idaho
    Posts
    767

    Re: NEEDED: 16197427 5.7L Manual Trans bin

    Yes, throttle follower is used extensively with manual trans, But there are some dedicated idle routines to handle a manual trans. In the .xdf there are some tables that state in the description they are just for manual a trans. I think they are near the bottom of the tables just before the 4L60E stuff.
    1978 Camaro Type LT, 383, Dual TBI, '7427, 4L80E
    1981 Camaro Z-28 Clone, T-Tops, 350/TH350
    1981 Camaro Berlinetta, V-6, 3spd
    1974 Chevy/GMC Truck, '90 TBI 350, '7427, TH350, NP203, 6" lift, 35s

  14. #14
    RIP EagleMark's Avatar
    Join Date
    Feb 2011
    Location
    North Idaho
    Age
    63
    Posts
    10,477

    Re: NEEDED: 16197427 5.7L Manual Trans bin

    Well good! Then I should just start with a 5.7L anything $OD Right? Wonder if they have a BCC for export? I have heard they run better than the ones for CA or FED. With as many options as there are with $OD I guess it doensn't matter...

    1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
    1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
    -= =-

  15. #15
    Super Moderator dave w's Avatar
    Join Date
    Feb 2011
    Posts
    6,268

    Re: NEEDED: 16197427 5.7L Manual Trans bin

    I've done six '427 type PCM's upgrades / conversions. For a Manual Trans and Non TCC Auto Trans (TH400 / TH350) I like $OE. For the 700R$ Auto Trans I like $OD. I attached a copy of the $OE BHDC.bin I've also been working with Excel, learning how to Record a Macro, so I can sort the data logs for both Near Idle / Off Idle tables.

    dave w
    Attached Files Attached Files

Similar Threads

  1. Injector size vs HP = pressure math needed
    By EagleMark in forum GM EFI Systems
    Replies: 24
    Last Post: 03-18-2012, 04:27 PM
  2. When is a fuel regulator actually needed to be modified?
    By mudbuggy in forum GM EFI Systems
    Replies: 5
    Last Post: 03-31-2011, 01:20 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •