Results 1 to 15 of 81

Thread: 1227747 to 16197427 Conversion PCM Swap with Wiring Pinout Directions!

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    RIP EagleMark's Avatar
    Join Date
    Feb 2011
    Location
    North Idaho
    Age
    63
    Posts
    10,477

    1227747 to 16197427 Conversion PCM Swap with Wiring Pinout Directions!

    I stole this information from Dave W. Writeup on CK5
    http://coloradok5.com/forums/showthread.php?t=270253

    He also got information from Thirdgen.org to start and I think the origanal was written by Fast355
    http://www.thirdgen.org/techboard/tbi/4 ... g-tbi.html

    Since I'm wiring one up starting today I figured I post up here the one Dave has added notes to.
    dave w

    Notes and information on converting to a TBI PCM

    I have had multiple people ask about re-pinning their earlier TBI cars/trucks
    to use the latest PCM. So here is the result. Information regarding the swap.

    PCM Swap/Tuning Notes
    8746/6965/7747/299 to 427 Truck PCM (Car showed, Trucks VERY similar)

    Old Pin---New Pin-----Color---------Function
    A1--------F6----------GRN/WHT------Fuel Pump Relay Control
    A3--------F16---------DK GRN/YEL---Charcoal Canister Purge Solenoid *** Not used on 87 GMC W/454***
    A4--------E1----------GRY-------------EGR Control
    A5--------E6----------BRN/WHT------Service Engine Soon Light
    A6--------E15---------PNK/BLK-------Ignition Feed +12VDC
    A7--------(1*)--------TAN/BLK-------TCC/Shift Light *** Investigate***
    A8--------F9----------ORN-------------Serial Datastream
    A9--------A14--------WHT/BLK-------Diagnostic Test
    A10-------F13--------BRN-------------Vehicle Speed Signal ***Output Speed not from DRAC set***
    A11-------B3---------BLK--------------Sensor Ground
    A12-------A1---------BLK/WHT-------ECM Ground 1
    B1--------E16--------ORN-------------Battery +12VDC
    B2--------B12--------TAN/WHT-------Fuel Pump Signal
    B3--------A5---------BLK/RED--------EST Ref Low
    B5--------A4---------PPL/WHT--------EST Ref High
    B6--------?-----------PPL---------------VATS(2*) *** Not used on 87 GMC W/454***
    B7--------(3*)-------BLK---------------Knock Sensor *** Not used on 87 GMC W/454***
    B8--------E12--------LT BLUE---------A/C Clutch Signal ***GRN Not LT BLUE 87 GMC W/454***
    B10-------E5---------ORN/BLK--------Park/Neutral Switch ***Investigate***
    C1--------(4*)-------BLK/PNK---------A.I.R. Converter Solenoid *** Not used on 87 GMC W/454***
    C2--------E7---------BRN---------------A.I.R. Port Solenoid (Diverter in trucks) ***Investigate***
    C3--------A7---------LT GRN/BLK-----IAC "B" Low ***LT GRN-BLK on 87 GMC W/454*** --- A7 1995 7.4
    C4--------A8---------LT GRN/WHT----IAC "B" High ***C4 WHT EST SIGNAL on 87 GMC W/454*** F11 1995 7.4
    C5--------A3---------LT BLU/WHT-----IAC "A" High ***C5 LT GRN-WHT on 87 GMC W/454*** --- A8 1995 7.4
    C6--------A6---------LT BLU/BLK------IAC "A" Low ***C6 LT BLU-WHT 87 GMC W/454*** --- A3 1995 7.4
    C7--------(5*)-------LT BLU------------High Gear Switch (In Auto Trans) ***C7 LT BLU-BLK on 87 GMC W/454*** --- A6 1995 7.4
    C8--------(6*)-------LT BLU------------Power Steering Pressure Switch ***Not used on 87 GMC W/454***
    C9--------(7*)-------PPL/WHT---------Crank Signal
    C10-------B8--------YEL----------------Coolant Temperature Signal
    C11-------B13-------LT GRN-----------MAP Signal
    C12-------B9--------Tan----------------MAT Signal(8*) *** Not used on 87 GMC W/454*** ***ALSO NOT SHOWN ON DIAGRAMS BELOW***
    C13-------A15-------DK BLUE---------TPS Signal
    C14-------E14-------GRY---------------5 Volt Reference
    C15/D14--A9--------DRK GRN--------Injector "2" Control *** D14 on 87 GMC W/454***
    C16------E13--------Orange-----------Battery (Inputed in place of Brake Switchfor TCC to function)
    D1-------A2----------BLK/WHT--------ECM Ground 2 *** TAN-WHT on 87 GMC W/454***
    D2-------B4----------PPL---------------MAP Sensor Ground
    D4-------F11--------WHT--------------EST Signal
    D5-------B2---------TAN/BLK---------EST Bypass
    D6-------A12--------TAN--------------O2 Sensor Ground
    D7-------A10--------PPL---------------02 Sensor Signal
    D15/D16--A16-----DK BLUE---------Injector "1" Control ***D16 on 87 GMC W/454***
    none ---- F8 -------unknown---------For Power steering switch input. (gregs78cam post 10)

    Swap Notes
    *** Throttle Kicker Enable disabled***
    *** Initiate Integral with Calibration Const. Not Running enabled ***
    (1*)= Use E2 for a shift light on a manual transmission or E11 for the TCC onan Automatic
    (2*)= Supported by the PCM if optioned in the Prom on an UNKNOWN pin
    (3*)= A.) Wire like 1995 P30 Step Van, ESC Module output to B7
    (3*)= B.) Wire like 1995 C10 Truck, Bypass ESC (Blue to Brown) and useLate TBI/TPI 305/350 Knock sensor
    (4*)= Air injection into converter not used on trucks, but PCM has severalother un-used outputs (Tuning Valve, Idle Kicker)
    (5*)= Not Used by PCM (I like to leave the small connector in place and pinin unused wires)
    (6*)= Supported by PCM if optioned in the Prom on an UNKNOWN pin(1994-1995 2.2 S10 Wiring Diagram anyone?)
    (7*)= Not used by PCM, Remove 3 amp "CRANK" fuse from fuse box andstore in small connector)
    (8*)= Supported by the PCM, but functionality will need to be enabled in theProm6965 ONLY- Will have a NC relay that the computer grounds to shut-off theA/C compressor when the engine is heavily loaded. The A/C will work eitherby removing the wire all-togather, or connecting it to pin E3 (A/C Cut-Off orCPI Tuning Valve output)

    I would also like to mention that the orange Serial Data wire needs to berelocated from the top row, Pin "E" to the lower row, Pin "M". You will alsoneed to scan the vehicle like a 1993-1995 G-Series Van, C-Series Truck,S-Series Blazer, etc with Auto transmission.

    Finally, this is a trick Haulin@$$ taught me, if you have a wideband and arelooking to get real-time AFR put into the datastream, hook the 0-5 volt signalinto pin B16 (Linear EGR pintle position feedback). With some adaption to theALDL Definition being used to decode the reading, you can get an AFR
    reading of 10-20:1 or so.
    Attached Images Attached Images
    Last edited by dave w; 12-06-2011 at 07:30 AM.

    1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
    1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
    -= =-

Similar Threads

  1. '71 Chev pick up 4L60E swap.
    By Six_Shooter in forum Gear Heads
    Replies: 13
    Last Post: 12-13-2013, 05:28 AM
  2. 1962 Suburban Engine and EFI swap.
    By Six_Shooter in forum Gear Heads
    Replies: 9
    Last Post: 10-25-2011, 01:15 PM
  3. Lucky's '96 Mustang DOHC Swap
    By Lucky in forum Gear Heads
    Replies: 19
    Last Post: 06-12-2011, 11:47 PM
  4. Fuel Pump Relay Wiring
    By EagleMark in forum GM EFI Systems
    Replies: 3
    Last Post: 06-05-2011, 08:52 AM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •