I finally got my motor swap done.But now I have run in to a problem.The motor is a bone L31 vortec 350 from a 97 donor truck.I am running the 350 tbi with 350 injectors with a dual plane vortec intake and tbi adapter from trans dapt.I replaced the fuel pump for the vortec pump in the tank.I contacted Brian at tbichips and had him do my chip.I installed the supplied 18psi spring.

My problem is my truck will start right up and idle good but smells like it is burning to rich.As soon as I hit the throttle it starts popping and backfiring through the tbi and exhaust.I have triple checked my timing and have it running at 0* right now.I have tried to advance it a little with no change in the way it acts.When I put the motor in I put all new sensor in with a rebuilt tbi.I starting to get frustrated as my truck has been down for a year now and I am wanting to start driving it again.I have a ALDL cable on the way so I can do some datalogging to see whats going on.

After seeing the other post about tbichips I'm beginning to wonder if I made a mistake.Would I have been better off to get the stuff to program the chip my self since I have the truck and can make changes as needed.I have been doing a lot of reading and it sounds like something I am capable of doing its just a matter of getting the stuff to do it.I went with tbichips as I wanted to get the truck up and running asap and Brian also told me he has done many chips for this swap so I pulled the trigger.

Lets say I want to burn my own chip.I know I need a burner and a G1 adapter and a couple chips.I have already downloaded tunerpro rt and have watched every tutorial on youtube I could find.I know I will need a base program to start with.Heres a list I came up with for burning my own chip.Should I ask for a refund on my chip and do the programming myself?

Moates Burn2 chip programmer http://www.moates.net/burn2-chip-pro....html?cPath=64

Moates G1 adapter http://www.moates.net/g1-memory-adap....html?cPath=64

C2 SSt 27SF512 chip http://www.moates.net/c2-sst-27sf512....html?cPath=26

Now my question is Where do I find a program or BIN file to use a base program to work with?