Are your cables still available? I have a '92 S-10 and will be converting from my stock 4288 ECM to an 8625 PCM.
Are your cables still available? I have a '92 S-10 and will be converting from my stock 4288 ECM to an 8625 PCM.
see, i'll buy one and it will probably be correct, so then I place an order for a dozen of them through the same source and i'll end up with a dozen incorrect ones and a lot of time/money wasted.
I would have to ask the seller to test every one of them for the 4 critical pins to make sure they make it to both ends and I don't know if they're willing to go through all of that trouble.
How are the cables coming along?
summed into a few words: not very. I still haven't too far into checking/revising the dimensions of the prototype connector Jim and his contact produced with my current planned circuit.... the planned circuit changes noticeably at times when I can't make up my mind about the best way to go about achieving certain goals, so I end up doing the same engineering work multiple times and I get burned out on it quickly.
hi I'm new to the forum i was sent here from GMT400.com i have a 1994 c1500 5.7l 350 tbi and i need the cable for the chip burning, i also have a question do i need to buy the chip separate? or you guys also offer one? thanks in advance!
Bookmarks