acceleration enrichment on off at idle

[Aholt91ss]

So in that post your saying I could plug these tables in with vortec head engine and add and remove timing

[dave w]

So in that post your saying I could plug these tables in with vortec head engine and add and remove timing

Yes.

[Aholt91ss]

i changed out the thermostat to a 195*
i ran the bfmf bin with all the flags on for manual it wouldnt go into closed loop and and map was high thinking maybe cheap map sensor from oreillys still have original gm but i pulled over went back to 4.3 manual bin to make it home

[dave w]

Any updated logs to look at?

dave w

[Aholt91ss]

Yeah I'll post them when I get home

[EagleMark]

i changed out the thermostat to a 195*
i ran the bfmf bin with all the flags on for manual it wouldnt go into closed loop and and map was high thinking maybe cheap map sensor from oreillys still have original gm but i pulled over went back to 4.3 manual bin to make it home

BFMF may be a bad start? It's an Export bin, most of them are Open Loop and run no O2 sensors do to leaded gas in other countries. Some I have dealt with could not be changed to Closed Loop. Make sure you can get closed loop before wasting to much time, or find a bertter bin file to start.

[Aholt91ss]

ok here they are 262013 25220131 logs are from this morning before i adjusted VE with spreadsheet the 00333 and 2356 are after but i didnt disable accel enrichment

[dave w]

I looked at the 00333.xdl and 2356.xdl. With the two combined the overall average is fair. I looked at the BJYL-$OD-5.7-Auto.bin file and compared it to a 5.7 with Vortec heads I've recently tuned. I think you need to add the values show in the screen shot to the current values in the BJYL-$OD-5.7-Auto.bin, and data log what happens? Use at your own risk!

dave

[Aholt91ss]

what about a closed throttle spark table

[dave w]

what about a closed throttle spark table

One option would be to make the closed throttle the same as the open throttle.

dave w

[Aholt91ss]

so add the values shown in the spark table to what i have or fill with values shown

edit:sorry i should have read your post better

[Aholt91ss]

What was the compare bin had in the picture? Just curious

[EagleMark]

It's his secret recipe, but he gave you the answer!

[Aholt91ss]

Haha yeah I kinda figured I went a little far on that question but I do appreciate all the help I've gotten from yall

Edit this maybe a dumb question but how do you know when to back off and give timing?

[Aholt91ss]

new logs with vortec timing table spreadsheet added from tonight

i didnt get around to adding the timing table from the attacthment earlier last night yet