Hi guys! I'm new here and I am wanting to convert my 54 Chevy pickup that has a 350 and 700r4 in it to a throttle body system. I have a complete 92 Chevy parts truck that I am going to take everything I need from. I have looked at several different sights that show people doing the conversions and a lot of them show pin out charts and pictures of their finished projects with the wiring harness hooked up.
I also have a 93' 4.3 V6 on a test stand with the trans hooked to it and the complete wiring harness from the engine plumb thru the firewall and all the dash wiring out of another truck that I have been playing with.

My 54' is a daily driver right now and before I start making it unusable by attempting something that I have never done I would like to know if anyone has a simple wiring diagram that shows only the basic wiring needed from the ECU to the ignition switch that will make the engine start and run properly.
I have been studing wiring diagrams and understand pretty much how the fuel relay, oil pressure switch, fuel pump and all work. But I don't want to destroy any wiring that I might need later. I have got the 4.3 to fire off by jumping the ign. wire and starter to hot and pouring gas in the throttle body, but for some reason I can't get the fuel relay to come on for the 2 second prime unless I jump the oil pressure switch, then the circuit stays hot as long as the battery is hooked even without the ignition wires jumped out.
All of the 4.3 stuff was pulled out of a badly wrecked truck by another person and some of the wiring could have been damaged or cut.
I guess what I'm asking for is more like a diagram of a complete aftermarket wiring harness or one that someone has drawn on their own. Thanks in advance!