what kind of processor in them?
otherwise, megasquirt or GM OBD1/OBD2....
what kind of processor in them?
otherwise, megasquirt or GM OBD1/OBD2....
1995 Chevrolet Monte Carlo LS 3100 + 4T60E
i wish i knew lol. ive thought about installing a GM ecm but unless i piggyback it, it would have to operate the 76RE trans
Basic OBDII data logging is not an issue, Scan XL Pro.
1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
-= =-
i just took a look at scan xl pro and it looks decent, as long as i can use that to do the same as with TPV5 then ill probably get it. im wondering if its even doable to tune this PCM though, if i cant flash it myself ill probably say forget it for now considering im already on a tight budget. MS or GMecm may be too much trouble, it was a bitch to tune the mustang with the 7730, especially with the E cam. and its a stick, hard to imagine tuning shift points for auto.
Diablo Sport has a LOT of Dodge tuning support.
http://www.diablosport.com/
The man who says something is impossible, is usually interrupted by the man doing it.
im sure they do, but for 1998 and up. LOLOriginally Posted by Six_Shooter
It's not uncommon to change a PCM/VCM (or whatever Dodge calls them?) in a GM. Look into system differences and it may be a swap?
1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
-= =-
I missed the "1997."
I haven't seen any software for older Dodges, not saying it's not out there, just never something that I've even stumbed across.
The man who says something is impossible, is usually interrupted by the man doing it.
Robert, if i can find out which processor the PCM has would that help?
if the processor can be determined, then the BIN can be disassembled.
BIN is probably in a FLASH PROM, so that would either require desoldering and then read in a burner or getting the PCM to spit it out over the DLC.
if it's a relatively common processor, chances are better that someone will be willing to take it on.
1995 Chevrolet Monte Carlo LS 3100 + 4T60E
LOL even people on the dodge forums recommend swapping to a GM PCM. So, what would be a good canidate for a swap, the 0411?
If you want to use OBDII, that would be the one I would choose.
The man who says something is impossible, is usually interrupted by the man doing it.
cool thanks
i think i found something that will help....
http://jtec.info/index.php?title=Unk...ew&action=edit
looks like a Motorola mc68hc16z2 processor
source....
http://dodgeforum.com/forum/2nd-gen-ram/279733-pcm.html
found some bins...
http://thespeedfreaks.net/showthread...CM-Flash/page2
Last edited by 34blazer; 12-28-2012 at 06:11 AM.
Posting Permissions
Reply With Quote
Bookmarks