Help with ALDL 5v to 3.3v setup

[-=Jeff=-]

Hello,

I am working on a project whee I am currently using an Arduino Mega to interface with the ALDL line and reading the data. However, I would like to use a Raspberry Pi Pico to do the same thing. The Challenge is the ALDL is 5V which is fine for the Mega, but the Pico is 3.3v and will not tolerate the 5v signal. I have a Bidirectional level shifter, but it is not working. However I have the Level Shifter after the Resistor and Diode for the RX and TX lines.

I use the same level shifter on aonther project with serial ports on a Mega and DUE, but I am not adding the components for the ALDL. Any suggestions to getthe voltage to a happy 3.3v for the Pico while being able to use RX and TX to the ALDL line?

[-=Jeff=-]

nevermind, I am looking a basic stuff and realized I can use the Max232 which will allow 5v on the ALDL side, Power but 3.3 volts and just work

[Terminal_Crazy]

nevermind, I am looking a basic stuff and realized I can use the Max232 which will allow 5v on the ALDL side, Power but 3.3 volts and just work

IIRC Steveo had a Pi Data Logger on his website

Mitch

[In-Tech]

nevermind, I am looking a basic stuff and realized I can use the Max232 which will allow 5v on the ALDL side, Power but 3.3 volts and just work

Hiya,
Max233 has internal caps so your breadboard will be a bit cleaner ;)