Okay, so I am making a lot of progress in the way of getting my VE tables fine tuned and getting the car running right, but I had a couple questions that I needed to get answered to make sure I understand this PCM. Everyone, including myself, that has tuned a 427 PCM knows that there are 2 VE tables for fueling. One table is the main open throttle table and the other is the idle VE table. There are 2 main parameters that tell the PCM which table to use and they are maximum TPS for idle VE and maximum MPH for idle VE. I think that I know the answer but want to ask the question anyway. The question is, if the values are not within range to meet BOTH parameters then the PCM will use the open throttle VE table, correct ? Example; the max mph for idle VE is 3mph and the max tps for idle VE is 2.7%. The actual vehicle speed is 15mph but the tps is 0%. In this scenario the PCM would still use the open throttle VE table because the car is moving faster than 3mph even though the tps is below 2.7%, correct ? If so, then if the vehicle speed was 0mph (accelerating from a dead stop) but the tps was at 10%, the PCM would also use the open throttle VE table, correct ? I have got the car running pretty good and now I'm fine tuning the spots here and there that are a little ouf of whack so that the car doesn't start doing funny things again once I re-enable the INT and BLM. Thanks in advance,
Phil
Bookmarks