What steps to tune VE table in speed density mode

[AngryCorvair]

Deleted post. Wrong forum

[sachem]

Good afternoon all,
I know i posted this a while back, but I'm not grasping this. I run so rich at idle that all you get is black smoke and my eyes burn. I tried increasing the ve cells at idle and decreasing. No change whatsoever. On the short log from last night, my injector pulse width is showing over 5ms. For a short time it was 39ms.my target AFR is showing 12.5 but i set it to 14.68. At idle the AFR is 9.0. I have the PCM set for speed density mode. What am I missing?