I own a 94 Southwind Storm motorhome (454 TBI w/4L80E) and thus far she has been very reliable. I purchased it back in Sept 2014 with ~45K on the odometer. I'm now at ~74K. I'm going to pull and rebuild the TBI here soon and was wondering if there is anything I should do while I have it off? This will just be a basic rebuild (gaskets, o-rings). I purchased a Delco rebuild kit for it Rochester 220 I believe. It has never been rebuilt and currently runs great. Once at operating temp it idles at 800rpm steady in Park. I also replaced the large AC condenser w/integral oil cooler this past Sept (leaking oil cooler) and clean out the radiator tube fins hwile the cooler was out of the way. If interested you can see the work I did here:https://www.gmt400.com/threads/conde...-cooler.59140/
One other thing...
Anyone know of the (ISC) on the 454 trucks? It speeds up the idle at first start. Was wondering if anyone knows where to source one. My current one is still functional but was wondering in the event it became non functional then what? It is the item in the following thread on the left...
https://www.gmt400.com/threads/help-...-please.41025/
Part number -
GM 17084953 Idle speed control actuator
Each year I make up a list of stuff to replace (due to age). Thus far I've replaced the following items using Delco parts...
1. TPS
2. IAC
3. EGR (Linear)
4. PCV
5. Idle control speed solenoid
6. Purge valve
7. VSS sensors
8. Aux fan motor
9. Plugs
10. Wires 8.5mm ceramic
11. Shift solenoids A & B
12. Alternator
13. Radiator cap
14. Upper & lower radiator hoses
15. By-pass hose
16. Engine - frame ground braid cable
17. O2 sensor (single wire)
18. Belts (3)
19. MAP sensor
20. Ignition coil
21. Pick up coil (rebuilt distributor)
22. Cap
23. Rotor
24. ICM
25 T-stat (195F)
26. Rebuilt driveshaft
27. Front hubs
29. Ceramic pads
30. Master cylinder
31. Trans wire harness (internal)
Much appreciated everyone
Not sure why the pic of RV is upside down LOL!
Reply With Quote
Bookmarks