sorry in advance if this is in the wrong area, or has been covered
fairly new to tuning in general and have been bashing my head against a wall trying to figure out how to do this with tunerpro
ive got a 2003 escalade LQ4/4L65E that had the pcm tuned by the previous owner using tunerpro and pcm hammer, ive been chasing my tail trying to figure out a lean misfire and bogging when trying to take off, fuel pressure is good, new iridium plugs ect so i finally decided to look into the tune itself after noticing that it would bog under 4k rpm but straighten out after that what i found was the pcm is programmed for a 5.3l
fortunately the previous owner gave me a flash drive with the factory tune and a copy of the tune he flashed into it. but they are different OS's.
whats the easiest way to go about doing a segment swap from the orginal tune to the new tune for the engine?
ive read it can be done in hex editior, but after looking into it i dont feel comfortable trying that just yet.
attached are both bin files if anyone would like to look them over and see if there are any other things that might have been done wrong
Thanks in advance!
Bookmarks