tapped out

[dhworkin]

The more I learn the less I know. It's time to pay. 95 c1500, 7427, L31R, vortec head, Edelbrock performer eps 2716, Lunati 20080660, flowtech 1154 FLT headers, no egr, wide band installed. Goes lean at 1600 to 1800 RPM's at all speeds.

[dhworkin]

lololokju.xdl With wb02 data

[ralmo94]

Surely you can learn, I would be willing to help you.

What stock bin is your tune based off of?

[dhworkin]

BJYK 95 342 gear. Thanks for any help, I've had a lot of help from this site and have learned more than I really wanted to. It's been years since I swapped the motor and started learning to tune. I know how to push the buttons because I've been trying to tune it for at least 5 years.

[dave w]

What .xdf?
What .adx?

The 2022.bin shows Mask AA, which is fine for emulation but not helpful for figuring out the .xdf / .adx information.

I guessed 4L60E, so I tried A217 $0D TP5 v250.adx from this link http://www.gearhead-efi.com/Fuel-Inj...Information-0D without results:

4-3-22.jpg

I'm attaching a Guess Work_2022.bin hoping it might help.


dave w

[dave w]

lololokju.xdl With wb02 data

Open Loop Only data logging? If so that explains why the spreadsheet did not have results. The spreadsheet filters out open loop data and calculates "Closed Loop Only".

dave w

[ralmo94]

Open Loop Only data logging? If so that explains why the spreadsheet did not have results. The spreadsheet filters out open loop data and calculates "Closed Loop Only".

dave w

That's how prefer to tune.
If that's $OD, I have an ADX that has an AFR error chanel that can be used with trimalyzer.
It makes thing a lot easier cause it filters out warm up temp, Decel, PE or idle, now mater how you have your histograms set up.

Away from laptop today so far

[dhworkin]

A217_0D_AEMx.adxAdvanced [ATTACH]17611[/ATTACH]D v200.xdf I loaded that bin, set the wbo2 parameters so it will work and changed it to go into closed loop. Will do a log run in a hour or so and post it. Thank you

[dave w]

A217_0D_AEMx.adxAdvanced [ATTACH]17611[/ATTACH]D v200.xdf I loaded that bin, set the wbo2 parameters so it will work and changed it to go into closed loop. Will do a log run in a hour or so and post it. Thank you

Let work off the same sheet of Music:

I'm not sure why the injector flow on 2022.bin is 86 LB/HR? The injector flow on Guess Work_2022.bin was changed to 80 LB/HR

I updated the Spark Tables on Guess Work_2022.bin so give that a test too.

dave w