Moates Flash & Burn question (chip not blank)

[EDZIP]

I understand that I should be asking this at the Moates site..figure wouldn't hurt to ask here. Been a long time since I worked with Moates and TunerPro.

If I drop in a new chip (27SF512) into the Flash Burn, load a bin and verify the bin load....checks out!

But ...When I hit the "erase" button with the same chip...the message indicates "erase succeeded" BUT when I "check for blank" it indicates chip is not blank and I can't get a successful bin load after that.

Any ideas?

Thanks