You helped a bunch, I appreciate the hell outta it! I figured out my dtc I didn't hook the fuel pump signal wire in on my relay. B2 is signal wire, monitors voltage to the pump. I will hook it up...
Type: Posts; User: ta2ed
You helped a bunch, I appreciate the hell outta it! I figured out my dtc I didn't hook the fuel pump signal wire in on my relay. B2 is signal wire, monitors voltage to the pump. I will hook it up...
Ok, 1st I want to thank you Brian. 94 w/auto worked!! I scanned the ol girl and got a dtc 54. Seems to run ok (@ idle) but I cleared the codes and it came right back. According to the solus it's a...
SWEET!!! thanks Brian. I'll try it again tomorrow or next day
Ok, I was using 94 but manual trans, could that be it?
Ok, I got everything wired n fired, cel is on & it's running rough. I plugged the solus pro in and it's not communicating. Any ideas?
Is the aldl for 7427 ecm wired the same way?
Ok, I have ecm mounted under the dash and all of my wires ran with the exception of the aldl connector. I need to know what wires go where on the actual connector from the ECM. Diagram anyone??
Thanks Dave. Oh & by the way I recived my chip yesterday 1 day AHEAD of schedule. I appreciate the prompt attention. I look forward to doing more business with you in the future & will point anyone I...
Thanks Dave! I have 1 other question.....imagine that! I will be running electric cooling fans, am I able to use the ECM to turn them on and off or do I need to use a seperate temp switch and relay?
Dave,
Is this the vss i need?
Speed Sensor, # 2PRS
The two-pulse square wave unit for all passenger car TBI installations, all computer controlled carbureted engines, and 1985–1989 TPI...
bonnieclyde, You hit it on the head,it is purple wire going to e13,its gettin gone TODAY!
Thank you all.
Not right off, but it was in the factory wire harness. This pic was taken after all the wire loom had been stripped off and I had taped what was left with masking tape to try and keep everything...
Well don't reckon that worked lol http://www.gearhead-efi.com/Fuel-Injection/newreply.php?do=postreply&t=3890
Thanks Dave, I know a pic is worth a thousand words, but damn if I can figure out how to get 1 on here lol. I'm gonna try to copy & paste 1 to see if it will work....
im currently in the process of installing a tbi off of a 93 c1500 on my 72 k5, have been reading on here and a few other sites and the wealth of knowledge on here is amazing. But I do still have a...
Thanks for the info on the connectors. Now on the eprom is there someone that reprograms these? I am lost when it comes to computer programming, my computer skills are basically non existent. ...
Thank Dave!
i will be using a manual 5speed trans. So will not need the trans controls, next question... How do I go about getting prom programmed for manual trans? I am totally lost in that area....
Ok, I have a few questions....quite a few actually and am not sure where to go or who to ask. I need to know what all wires I can cut out of the harness. Also how or will the automatic trans control...
Thanks Dave. I just hope I don't sound too ignorant lol. My tbi swap consists of a setup out of a 94 c1500 350/4l60 e ecm 7427 & harness. I want to install this set up in my 72 k5 350/5 spd. What...
Hello all & thanks for the add. My name is Frank. I'm from southern ohio( bout as far south as you can go without hittin water)My current project is a 72 k5 blazer. I plan on swapping from carb to...