It looks like the patch was not applied. I don't know how or where they got the BIN file from and what software they used. So if I want to see those values in TP I should apply the patch and burn...

I brought the vehicle in to TPIS in Chaska, MN and paid them to see why it wouldn't start. They found that a pin was folded over in the distributor coupler. After starting the engine began to...

The issue is it won't start. I have spark but the injectors are flooding the engine. It will fire off if I go WOT but then all the excess fuel catches fire. Now that I've checked so many things...

Fuel pressure checked out at 12PSI before the TBI unit in line. Here's a pic of my temporary gauge install. I'm wondering if the injectors could be not working properly. This system did come out...

Here are the two successful data logs. The first one is a little longer with a few seconds of cranking. That's when all the lines really start moving around.

The one with 545pm in the title is a...

Well good call EagleMark. I spent about 20 minutes today with Moates remoted into my laptop plugged into my vehicle. After trying a bunch of stuff including moving the switches on the AutoProm, he...

Yep, this is how I have it installed. I'm thinking I may take my equipment over to my brothers house and hook up to his 1990 Chevy Work truck w/350 and TBI. If I can data log on there that will...

Switched ALDL wires back and the CEL is working properly now. Blinks once then continuous on. Went through the Autoprom procedure a couple times and switched ignition on and off to. Still same...

1. Got emulation to work following your procedure :) I wasn't hitting the up arrow icon before. After this I connected to data log and viewed sensor values in item list. Still same wrong values as...

Just installed the older driver and set it up in device manager. Before I connect the screen looked like this:
5132

And after connecting for data log it went back to wrong values everywhere:...

I'm back messing with my Jeep today. I noticed that the gauges were at normal levels on the dash before and after connecting to datalogging untill I pressed the print screen button on my laptop. ...

I got connected by using the APU1 instead of setting it to pass through mode! I also switched to $42-1227747-V5.2.adx. The CEL does the routine you described. Now, the Data dash shows values that...

I've tried connecting to data log without success and haven't found answers or troubleshooting help anywhere online. Two things I suspect at this point:

1.) I may need to change the BAUD to 160...

For checking sensor voltages I'd like to use the datalogging/scanning capability of TunerPro. That's what I'm going to try tomorrow. It's not clear to me how this will show up in the software, but...

Hi Everyone,

This is my first venture into the tuning world and my second post onto this forum. I just purchased the Moates APU1 system and I have the new adapter soldered into my board and I'm...

Hi, new member to this forum here.

Just purchased the APU1 from moates. Have a TBI system off 88 suburban in my CJ5 with 350 engine. Need to get it running first and foremost. All wiring and...