Ok I found them. The VE table only accepts numbers up to 100. If I needed to add more fuel would it be better to raise fuel pressure or fudge one of the "inj flow rate" or "cyl volume"? In the past I...

Thanks! I'll have to look for that

Hello. It's been a while. I recently installed a cam, intake and long tubes in my truck (95 K2500 454). It runs amazing after a little tuning and now I want more of course. I've been sitting on a...

I don't have one anymore. I put a stock 350 in my 92 Astro back in the summer of 2000. After that I had a couple more I converted to small blocks. One with TPI from a Corvette. Another on was 4wd...

Looks like the technical help is here. I just popped in to say this project is dear to my heart

I can't answer directly but there are similar tables in my 427/$31 system. I have successfully firmed shifts by adding numbers to the shift tables whose values are shown in "psi"

I've been successfully modifying my tables for shift firmness. I'm still not sure which table is the "best" for increasing shift firmness. Is it the force motor table or the line pressure adders?

I have a comment for the mechanical part only because I've been there done that. I had the exact same thing happen to me once. I can tell by how far down the set screws are in your poly-locks that...

Use $42 definitions. Are you attempting to read a 2732 or 27C256? If I read this right it sounds like you tried to dump a 2732 chip with TP set to read 27C256

What would you say your pressures are at? I made a small increase of 20psi to the "max pressure" and the "pressure vs tps" table. I didn't notice much difference. But I'm waiting on my TransGo kit...

I'm not quite sure which mask I'm going to use yet. I figure they both will have similar tables to control shift timing and pressure. For now I'd like to stick with $31 and firm up the shifts. I read...

I use a 3-wire O2 in everything I tune. ACD part # AFS-74. Recommended by RBob for use with his EBL and the 7747. I installed one in my truck recently. Using a relay for key-on power to the heater...

Cool. Thanks fellas. Seems like a good place to start. I have a badazz 4bbl TBI a friend of mine made (CNC operator). It's got 4x 72# injectors in it. 2.4ohms if I remember. Ran great on EBL modded...

Interesting. Mine runs pretty good for all stock but I wouldn't be opposed to trying something else. Right now I'm using BMHM. Any particular $0E BCC you'd recommended using?

Just to follow up. Replacing the knock sensor fixed the TCC issue

I ran a Weiand 142 on a small block for a few years using TBI injection. I had one of the original EBL's. Stock BBC 90# injectors worked fine for me at 30psi

I wouldn't pair a SC with a cam that...

Hello! I'm new here but not to tuning. I used to post of thirdgen about 15 years ago (holy crap I'm gettin old). I had small blocks in Astro vans. I read a lot of the threads and some familiar...