Bringing TBI and Multi Port Fuel Injection to a New Level.     EFI Conversions and Tuning! Seattle to Portland! E-mail Tuning Consultant!

Search:

Type: Posts; User: tayto

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    453

    nice truck, wish I was closer and the Canadian...

    nice truck, wish I was closer and the Canadian dollar better
  2. Replies
    1
    Views
    126

    I found this cable on amazon for $20 CAD:...

    I found this cable on amazon for $20 CAD: https://www.amazon.ca/dp/B07G257MM4/ref=cm_sw_r_apa_i_shaZEbTS8VK2V Much cheaper than Moates original CABL2. I will have to solder the wires to different...
  3. Replies
    1
    Views
    126

    WTB: Moates CABL2

    Looking for a CABL2 for ALDU1, moates doesn't make one anymore more. Was always meaning to buy one and now that I need one they're gone. Figures.
  4. Replies
    21
    Views
    787

    what plugs are you running? i went from a 44LTS...

    what plugs are you running? i went from a 44LTS to a 42LTS and knock counts went down from maxing out in a 10 minute drive to virtually nothing. If i recall after the plug change most of my knock...
  5. Replies
    16
    Views
    1,008

    LPG also likes high compression, don't be affraid...

    LPG also likes high compression, don't be affraid to go over the "norm". keep quench tight, .040" and under. you can always use the TBI ECM to control only timing. you will have to have a TPS and MAP...
  6. what brand did you buy did you pull intake and...

    what brand did you buy did you pull intake and clean egr passages? with the block off plate is the CEL on? if no, i would leave it and move on.
  7. Replies
    30
    Views
    1,803

    you'd have to have an injector stuck open to wash...

    you'd have to have an injector stuck open to wash the walls down. i took a tuning seminar many years ago, if anything you'd want rich from starting out. i'd rather change plugs vs bearings or pistons.
  8. Thread: AFR ?

    by tayto
    Replies
    16
    Views
    820

    every tbi vehicle i have owned or worked on for a...

    every tbi vehicle i have owned or worked on for a friend we have upgraded to the TPI pump (ac delco only!!). made a world of difference on my caprice even before i replaced injectors and played...
  9. Replies
    7
    Views
    1,234

    no it does not kill the fuel pump if there is no...

    no it does not kill the fuel pump if there is no oil pressure. the circuit is there so if the relay fails the pump will still get power once the engine has 3 or more psi. i suspect the circuits being...
  10. Thread: AFR ?

    by tayto
    Replies
    16
    Views
    820

    check injector part numbers, perhaps they're the...

    check injector part numbers, perhaps they're the wrong ones.
  11. Replies
    8
    Views
    522

    don't you usually want to pull timing at high rpm?

    don't you usually want to pull timing at high rpm?
  12. If you are not running a 4L60E or 4L80E and have...

    If you are not running a 4L60E or 4L80E and have no plans too EBL may be the way to go. http://www.dynamicefi.com/EBL_Flash.php handles up to 30psi of boost and a laundry list of other features. I...
  13. Replies
    4
    Views
    457

    the calibration will most likely only use 1 knock...

    the calibration will most likely only use 1 knock sensor. perhaps there is an option to enable it? i find it funny that the fbody had less drivability stuff vs the bbody. ex: fbody used a...
  14. Thread: TBI & SBC parts

    by tayto
    Replies
    3
    Views
    1,143

    updated parts list, prices lowered

    updated parts list, prices lowered
  15. Replies
    6
    Views
    574

    I have an EBL flash for sale, PM me if you're...

    I have an EBL flash for sale, PM me if you're interested. it made my stock '89 caprice run better with a provided base calibration before i even started messing with it.
  16. replacing the TBI fuel pump with a TPI pump,...

    replacing the TBI fuel pump with a TPI pump, along with modifying the regulator to run @ 13 to 14 psi made a noticeable difference in power and drivability on my 89 caprice. food for thought...
  17. Replies
    32
    Views
    2,462

    AFAIK a hall effect generates a DC square wave...

    AFAIK a hall effect generates a DC square wave output vs a magnetic pickup which generates an AC signal, but I have never verified with a scope.
  18. Replies
    32
    Views
    2,462

    go on rockauto looks like you can order magnetic...

    go on rockauto looks like you can order magnetic pickup and reluctor for a carb'd setup. weather it wil bolt into your EFI dist, i am not sure.
  19. Replies
    32
    Views
    2,462

    you will need to use a dist (or modify) with a...

    you will need to use a dist (or modify) with a magnetic pickup. i dont believe the gm module will work with hall effect. your carb'd distributor should have magnetic pickup? if so can remove vac can...
  20. Replies
    32
    Views
    2,462

    yes that's it, hard to believe i remembered that...

    yes that's it, hard to believe i remembered that from over 9 years ago. hopefully that gives you some ideas....
  21. Replies
    32
    Views
    2,462

    do a Google search for Toyota gm efi conversion....

    do a Google search for Toyota gm efi conversion. he used the pickup out of a stock Toyota distributor and remotely mounted a GM ignition module on an aluminum heatsink. if distributor has mechanical...
  22. Thread: Cam Signals

    by tayto
    Replies
    7
    Views
    886

    with the '411 why not just run CnP and be done...

    with the '411 why not just run CnP and be done with it?
  23. what brand of injectors did you go with. You're...

    what brand of injectors did you go with. You're better off getting a used set professionally cleaned and flowed. Has fuel pressure been verified?
  24. Replies
    9
    Views
    1,072

    isn't there a transgo change up to convert the...

    isn't there a transgo change up to convert the PWM 4L60Es to non-PWM?
  25. Thread: TBI & SBC parts

    by tayto
    Replies
    3
    Views
    1,143

    Prices converted to US dollars. I am surprised...

    Prices converted to US dollars. I am surprised there has been no interest for anything. I think everything is priced reasonably. I may do "package" deals if multiple things are bought.
Results 1 to 25 of 100
Page 1 of 4 1 2 3 4