dave,
I am looking at using some of the "junk" I have laying around here. With the change of plans, I now have a MSD digital 6AL box and a 8360 magnetic pickup distributor laying around. So it...
Type: Posts; User: Mad Machinist
dave,
I am looking at using some of the "junk" I have laying around here. With the change of plans, I now have a MSD digital 6AL box and a 8360 magnetic pickup distributor laying around. So it...
I had started a thread on doing a TBI on a 350 TBI in a YJ. Well through my travels and do to a change in plans, the L31 TBI is getting carbed and put in my '73 pickup and the 383 is going in my...
I'm trying to keep this emissions legal. We don't have it here yet, nut I think it is coming soon.
7506
What I started with. And a few hours later....
7507
I still need to pull the fuel pump and the wiring. I am in no real hurry here, but will update when I do something or a question is...
Well, off to a late start, but I have the harness modified. It was a lot easier than I expected. Even with the 4L60E it is basically plug and play.
My Wrangler is an '87. It WAS fuel injected, if you could call it that. I did the Nutter Bypass which eliminated the ECU and then put in a HEI ignition. All wiring attached to the ECU is gone.
...
This is kinda what I am worried about. My Wrangler is an '87 with the 4.2L. lots of power through 27 years old switches could get a little toasty.
Looks like this may be down to connecting three to the YJ harness if I keep the under hood fuse block. One for the ignition, one for the starter, and one for the check engine light.
After almost...
IGN-E fuse for the trans fuse? May end up keeping the stock underhood fuse block as the fuel pump relay is already there and if my measurements are right, the stock K1500 fuel pump may fit the YJ...
Thank you for the heads up on the fuse block. Didn't know they used brass strips. Wonder if this is already done since the ECM-B fuse is there and it is always hot.
I plan on going through the...
I think I figured out how to keep the underhood fuse box.
http://www.wiringproducts.com/200-amp-12-volt-high-power-relay.html
With the auxiliary connections available on the fuse box, wiring up...
EagleMark,
I think I didn't explain what I want to do well enough. I want to keep the 4L60E as the AX-15 in my Jeep is on it's way out. I also want to keep the NP241 as it is worlds better the...
Since my oldest one rolled his truck, I'm looking into swapping the engine, trans, and transfer case into my YJ. Should be fun.
The truck was a 1995 Chevy K1500 with the 5.7L TBI, 4L60E trans,...
I am about to start project and I'm very happy to have found this forum. Hopefully you all will be able to help me out here.