Search:

Type: Posts; User: fastacton

Page 1 of 4 1 2 3 4

Search: Search took 0.02 seconds.

  1. Thread: ALDLdroid

    by fastacton
    Replies
    1,128
    Views
    905,708

    If nobody comes up with a better answer, you...

    If nobody comes up with a better answer, you could try using files for other ECUs and see if any of them works. I have no idea of what would even be close, though.
  2. Replies
    47
    Views
    91,820

    You'd probably be better off getting your...

    You'd probably be better off getting your preferred tuning suite first (or getting someone else to flash a starter tune on it). You won't even be able to start a 0411 setup until you've went in and...
  3. Replies
    47
    Views
    91,820

    It should be easy to do as long as you can come...

    It should be easy to do as long as you can come up with a crank sensor. Just use the distributor from a '96 and up Vortec engine. The 0411 was used on the Vortec 350 engines in the later vans, so...
  4. Replies
    2
    Views
    2,895

    Welcome! A Jag with TBI should be relatively...

    Welcome! A Jag with TBI should be relatively easy with the exception of the dual tank plumbing. What part of CA? I'm in Fresno and have a couple of Series I XJ Jags myself (they're mothballed...
  5. Replies
    4
    Views
    3,834

    I was a charter member of CK5, but haven't been...

    I was a charter member of CK5, but haven't been on the site in a while. Here's a link to mine with some specs: https://warrperformance.com/?page_id=189
  6. Replies
    4
    Views
    3,834

    Welcome! It does suck to have to deal with our...

    Welcome! It does suck to have to deal with our smog requirements, but there are things you can do. I'm in Fresno and have a TBI K5 as well (but mine is smog exempt). We'll try to help when you're...
  7. Thread: ALDLdroid

    by fastacton
    Replies
    1,128
    Views
    905,708

    I'm getting ready to put a tablet in my 280Z...

    I'm getting ready to put a tablet in my 280Z using ALDLdroid as my primary gauges (an upgrade from the smartphone I've been using). I'm planning on using the Tasker app to wake the tablet and start...
  8. Replies
    39
    Views
    23,294

    Might as well stick with the heated 3 wire. ...

    Might as well stick with the heated 3 wire. It'll work fine with the 5.7.
  9. Replies
    1
    Views
    2,549

    It sure can. The info on LT1swap.com will give...

    It sure can. The info on LT1swap.com will give you the pin that needs to be wired up. It's meant to be a momentary switch.
  10. Replies
    3
    Views
    4,461

    I've been wanting to do some more testing on this...

    I've been wanting to do some more testing on this stuff, but haven't had a chance lately. I seem to recall the 4 pulse from JTR not working with a DRAC/VSSB, so the two pulse might be the better...
  11. Replies
    4
    Views
    4,973

    Normally it'll be easy because fuel is spilling...

    Normally it'll be easy because fuel is spilling everywhere. These regulators are very simple, it's just a spring and a diaphragm which works as a bypass valve and there really isn't anything to...
  12. Replies
    4
    Views
    4,973

    If you pinch the return line and the pressure...

    If you pinch the return line and the pressure doesn't rise it is a pump problem. How would a regulator be able to keep the pressure low if it doesn't have a place to relieve the pressure (unless...
  13. Thread: Odd Fire TBI

    by fastacton
    Replies
    92
    Views
    115,515

    Sometimes theory and math don't prove out in the...

    Sometimes theory and math don't prove out in the real world. Based on what 1project2many explained about the time between pulses being how RPM is calculated (I didn't know that), it might not work...
  14. Replies
    5
    Views
    4,765

    Very well could be a bad read or a failed burn to...

    Very well could be a bad read or a failed burn to the chip. Using $42 to look at it, the VE table is wacky too. I'd double check all the settings and try to read it again, but it might be just junk.
  15. Replies
    18
    Views
    13,256

    I have the same problem with one of the 7747 to...

    I have the same problem with one of the 7747 to 7427 adapter harnesses I built. I've triple checked everything and it seems fine, but just doesn't work right. It can be very frustrating.
  16. Thread: Odd Fire TBI

    by fastacton
    Replies
    92
    Views
    115,515

    So, for the odd-fire HEI, they must have used a...

    So, for the odd-fire HEI, they must have used a V8 sized distributor, but with a more specialized reluctor and distributor cap. What were the results when someone tried to use a 7 or 8 pin module...
  17. Thread: Odd Fire TBI

    by fastacton
    Replies
    92
    Views
    115,515

    I'd have to agree with Six_Shooter on this. I...

    I'd have to agree with Six_Shooter on this. I don't see why an odd-fire HEI distributor (which I understand is based on a V8 HEI with two dummy posts and a 6 point reluctor) couldn't be used along...
  18. Replies
    18
    Views
    13,256

    Have you tried throwing a factory chip into the...

    Have you tried throwing a factory chip into the ZIF and seeing if it would still work? That should ensure that there were no problems introduced by installing the ZIF.
  19. Thread: V8 Astro TBI

    by fastacton
    Replies
    45
    Views
    33,523

    Were the correct legs on the ZIF tied together? ...

    Were the correct legs on the ZIF tied together? I believe this needs to be done to make it work if you're not using the Moates adapter.
  20. Replies
    10
    Views
    12,128

    The years are wrong for the photos on the link. ...

    The years are wrong for the photos on the link. That's a Vortec style injection setup which was mostly '96 to '99. There are plenty of them in the junk yards. Would you have a way of keeping them...
  21. For HP Tuners, you normally need to use 2 credits...

    For HP Tuners, you normally need to use 2 credits per VIN, so it's closer to $100 (you can get discounted credits). Where it starts getting cheaper is when you unlock model year groups, but you have...
  22. Replies
    10
    Views
    12,128

    The 280Z used injectors with hose on the ends,...

    The 280Z used injectors with hose on the ends, that might be something to look at if they have the flow you need.
  23. Replies
    3
    Views
    4,089

    I have a similar issue with a cheap serial to USB...

    I have a similar issue with a cheap serial to USB adapter I use. I think mine isn't properly shielded, maybe you have a similar issue?
  24. Someone else may be able to describe it better...

    Someone else may be able to describe it better than me, but the BIN is the tune. It has all of the parameters required to ensure that the engine is getting the proper amount of fuel and ignition...
  25. In TunerPro, go to Tools / Preferences / Data...

    In TunerPro, go to Tools / Preferences / Data Acq. and ensure that Autoprom is selected under interface type.
Results 1 to 25 of 100
Page 1 of 4 1 2 3 4