Major victory today! It looks like all of the issues I was having were due to the Red Devil River cable and the fake FT232RL chip. The Moates cable I ordered works perfectly. No dead spots while...
Type: Posts; User: Casey96SS
Major victory today! It looks like all of the issues I was having were due to the Red Devil River cable and the fake FT232RL chip. The Moates cable I ordered works perfectly. No dead spots while...
Well running the new ground wires directly from ALDL pins 4 and 5 to the ground post on the inner fender changed nothing. I did find that the ground stud was loose where it bolts to the fender but...
What would be the best way to troubleshoot the #4 and 5 grounds on the ALDL connector? Does the cable rely on both of those or just one of them? Would it be worth trying to run a temp ground wire...
So I ran a new 20-ga TXL wire from my ALDL pin 9 directly to my ECM pin D30. I crimped and soldered a new pin and terminal to the ends of the wire. EFI Connection is a great place for these things! I...
Cool! I will run a new wire directly from ALDL Pin 9 to ECM D30. I did not think of that. I know the EBCM is wired into the tan wire on my car based on the wiring diagram in the FSM. I believe that...
It starting to look like my 96 F body with an OBDI PCM is wanting to be a real bastard to log and tune. I previously switched my tan and purple wires from my ALDL to PCM so that it would take the...
I got it figured out after searching the net and looking at the wiring diagrams in my FSM.
Swapped #2 and #9 wires on the ALDL connector
Swapped #7 and #30 wires on the blue PCM connector
...
It looks like my Red Devil River Cable is reading on Pin 9 which would be Serial Data (UART). (See Pic)
Car is a 1996 with the OBD-II ALDL connector. I converted over to an OBD-I with the correct...
Hey Steve finally had a chance to get my car back together and do a little data logging yesterday with the wideband disconnected. The ABS Inop and Low Trac lights seems to be turning on occasionally...
I know nothing about developing or writing software, but any ideas on why my wideband would work fine with datamaster but not EEHack or Winflash? Would there be anything I could play around with in...
I do not have an oscilloscope. I do belong to a car club I can ask to see anyone has access to one. Would it be a real involved process to figure out the problem if I can get access to an...
Tried it both ways. I get an error if the signal wire is connected or if it is disconnected. The only time I do not get an error is if the power to the gauge is disconnected.
Thanks for reply Steve. Awesome program you have put together. Looking forward to playing around with it.
My white analog output wire is connected to the Red and Black wire of the AC pressure...
Hi Guys! Trying to get EEHack to work with my Wideband. It seems that the wideband is causing interference with the serial connection.
I am getting the error in EEHack "SERIAL: ECHO CORRUPT! (bad...