Plus getting ready to move myself, teh wife, and two stupid cats&, 3 vehicles to Rapid City , SD.. 47 days away !!

I'm in standstill mode as far as tuning. I had to drop the truck over to my buddys to yank the old engine meanwhile im trying to get the new one on the dyno and get over there to clean and paint the...

I always have a backup plan... been around too long not to, plan for the worse expect the best

Well I think if we compare carb to carb Dual plane does what I want and need it to do. My initial thought was if I couldn't get this TBI to tune right I'd have a backup plan to go spreadbore carb,...

we'll agree to disagree then...ok?

higher RPMS like the single plane for sure. Dual plane is better for low end grunt... it's only cammed for 4500rpm

I got a little further today. I was able to emulate a chip , run the truck on that BIN file, I made changes to Idle speed to make sure I knew what I was doing, commited them to the running config,...

I wish I knew what this Ostrich is ... Do I need that too?

I appreciate your answer but I'm so not there yet... I can't even get a BIN on a chip... I sent a letter to Moates... we'll see how that goes.. these dipswitches could be the culprit, or perhaps the...

at what stage are you at? are you further than me? It's a like a video game, we're breaking through levels, and this level is a bit tough, but the next level maybe we'll get an extra weapon or...

it seems pretty obvious that this software is effective. I did homework on a standlaone system and 900 is a little light IMO. that being said, I have what I have and I firmly believe it will work at...

I wish they had of told me everything I needed... last week it was G1, now it's HDR1, whats next... I'll pay the money, that's not the issue, just tell me. ( Moates) not you.

and if the ribbon cable needs to be connected, how does the truck have anything to run off of?

I'm missing something or overthinking it.

I'm getting warmer.

1st things first. with a g1 adapter I need to have a chip with a bin on it because it seems impossible to get that config off that chip without removing it.. agree?

2....

I went through the same thing, awaiting adapter, etc... I want to do the same thing, all these videos and no description on how to pull a stock BIN off of my truck.. I searched for two days. no luck....