Well, its fixed, replaced ECM 7730, CST agaim , reset timing and FP. Starts, trail testing soon. Hell I am Happy as a Seawhawks Fan!!
Type: Posts; User: Jeep09
Well, its fixed, replaced ECM 7730, CST agaim , reset timing and FP. Starts, trail testing soon. Hell I am Happy as a Seawhawks Fan!!
Not sure. If it was in the Affordable FI or the Painless harness it should have been hooked up. I will look into it
the pump is totally manual, race car style dash, FP gauge with vacuum, turn the switch on and it loads the rails, you can hear it dump fuel into the tank.
Here is the drop box link and download https://www.dropbox.com/sh/6a4pwas2warpsi3/FdITwonvfO
I do,I will look for them
thanks, I did minorly pick there brain. I did not buy direct as this was purchased as an unfinished project that was a couple years old. I got Tuned Port Injection Services to do a PROM for me based...
Hi, I have just got my Moates cables and started data logging using the TTS program. Since my OP #01 I have:
- new regulator in alternator and confirmed 14.5 volts
-New CTS sender ( did help)
-...
It has Edelbrock heads, 1st FI Manifold, Affordable FI harness, headers, small cam. Tune was done from supplied info by Scott Hansen from Reno, NA.
I am just about ready for some data logging, new...
thanks, I am trying to learn this stuff.
I replaced my coolant temperature sensor and my hard starting has got a bit better. As soon as I did this my AIC was acting weird. A noticeable "vacuum sound" it never had before on start up and for...
Will try the 6 degrees....
Spoke to AFI today, 6 BTC is the start point for the tune...could go as high as 8-10 BTDC. See if this helps.
TTT anybody?
Trying to get some basic things dialled in. I have reset my initial timing, unhooked blue wire at distributor , set timing to 0 degrees. Shut off , reconnected wire.
Is this a good place to start/...
[QUOTE=EagleMark;30355]:welcome2:
Sounds like a cool crawler! :thumbsup:
TPI fuel system should be 43.5 PSI at idle.
The AFI manual says 40 psi without vacuum hooked up to the regulator
Any general things to check? I bought this crawler semi finished, just getting the bugs worked out.
AFI Chip file 57FI9058.
SERV NO 1227730
866901 M821200888
SBC 355 CID , mild cam, Edelbrock heads, 10.5:1 comp. it has 1st Fuel Injection manifold, and Affordable FI injectors, harness & ECM. AFI distributor. All parts as new, a few hours running.
Its in a...