Got my ALDL cable in the mail today.Ready to do some data logging but dont know which file I need.I have the 16196395 ecm with BDXJ chip.
Also where can I find the bin for the 96 gvan with the tbi...
Type: Posts; User: jbrenneman13
Got my ALDL cable in the mail today.Ready to do some data logging but dont know which file I need.I have the 16196395 ecm with BDXJ chip.
Also where can I find the bin for the 96 gvan with the tbi...
Well the CEL is off now.The transmission harness wasnt plugged in all the way.I readjusted the valves today and found that the valves on #3 cylinder were just a little to tight.While idling it doesnt...
Yes the motor did run before the swap.The last time it ran was nearly 4 years ago.I went through it and replaced all the gaskets before I put it in to freshen everything up.
I will readjust the...
Ok heres another thought.Im wondering if one or more of my valves isnt a little to tight causing it to pop through the exhaust?I remember one of my friends had an old chevy that he put a new sbc in...
I will try that tomorrow and see what happens.
That was my first thought that I may have put the wrong chip in but checked and it is the one that I got from tbichips.com that is suppose to be...
Yes it does
Thats what I thought about the timing.
First of all thank you for your help with this.
I turn the key to run and the CEL comes on goes off then comes back on and stays on.The only code I got...
Ok I got the MAP sensor worked out.Some how the vac line for the brake booster came off at the fitting in the intake.I'm still having trouble with it popping through the exhaust while idling and...
The Chip Code is BDXJ
Yes the vac line for the MAP sensor is hooked up to the center port in the rear of the TB between fuel lines.I have checked the connector and the the wiring in the harness...
The ECM number is 16196395 so I'm guessing its the same as the 16197427 ecm?
My FP is running at 18psi which is what I was told I needed.I have DTC Code 33 (MAP sensor circuit voltage high low...
I finally got my motor swap done.But now I have run in to a problem.The motor is a bone L31 vortec 350 from a 97 donor truck.I am running the 350 tbi with 350 injectors with a dual plane vortec...