Not that you can't make one and you sound tech savvy but time to get on with tuning. I'd pay the man and get one already made is my opinion. My cable has no lag and goes right to "DA Connected" when...

So far with O2 wiring I have found a 2' section of harness that has a break and needs repair. Going to tackle it after vacation with the kids this week as I'd rather open the loom up and repair than...

Hey 95stroker, I'm new here also and came with Tunerpro RT freshly installed looking for bins and files to make it work. Dave is the same one that pointed me in the right direction and after being...

Today I checked O2 for voltage with key on engine off and found no power or ground to sensor. Ohm test on sensor shows it to be in proper order so tomorrow I will test ECM output to wiring and see if...

Watched data while driving today and noticed code 13 O2 sensor set right away. This code had appeared recently but was always DTC 23 and 25 but now with O2 setting DTC 13 ECM stays in open loop and...

Hey guys, My MAT sensor is stuck at 61 and unresponsive. Replaced sensor and no change still 61. Looped connector and still no change in value, checked continuity from sensor to ECM and all good....

Can you guys point me down the road or give your input. All new to Datalogging and diag from sensor values and would like your opinion on what I have. I have a 91 350 TPI with 305 heads running 10:1...

I found my issue, It was my thinking the 3.0 usb port would be com port3.In fact the 2.0 port was com port3 and was occupied with a jump drive for storage files. Swapped drive and cable and now live...

Thanks, I know it's probably something silly and at this point I'm guessing I'm over thinking it. There's so much info out there I'm bound to come across it. Thanks again Dave!

Thanks Dave! Having issues with ALDL/USB connecting with tunerpro rt. Checked port and is set at 9600 but not sure on other settings. Tried with cable in resister mode and without resister any ideas...

Thanks for having me! Have a 1991 350 tpi manual trans that I'd like to keep churning out the torque so I find myself here. Although I haven't a lot to share yet I'd be willing to listen to what must...

Goodday Sir, Tech ignorant old dude that wants to make pwr. Need help with adx and definition bin for tunerpro rt 91 f-body 350 tpi manual ecm 1227730 looking to scan and data log only Thanks