OK, you're right, it's a pointer.

So the program goes like this:

3789 B6 01 93 @34 ldaA l_0193_CoolTmp_fltrd_$f0_max_$e0 ; Load Coolant Temp to A
378C CE 26 91 ldX...

Actually, there is a mistake in the EEXtra.xdf. The 0x2680 is used as an immediate value, not an address. So there are actually 4 places that have this value hardcoded ( E side lines: 0x376A, 0x379B,...

I think the parameter you are looking for is "12680 BASE BPW FOR STARTUP ,used to calc prime pulse width used with 2682" available in EEXtra.xdf

The looked up values from prime pulse tables are...

You can view raw data in TunerPro, just right click on the table and select "Show raw hex".

That's why I combined those three prime pulse tables into one - to make scaling them for different injectors just one multiply or divide operation.

Yes, I modded the XDF here and there to suit me better.

Commented disassembly is here.

Basically, at startup there will be two prime pulses delivered (1st and 2nd, as per tables) at each low...

There you go, I updated Steve's EEX.xdf with some parameters, including minimal injector PW.
Stock minimal PW is 1.4ms.

11971

Bosch D3 series injectors are well controllable at low pw, so I don't think you'd run into problems. I used them on 383 sbc that made 420hp on a dyno.
In your case red Bosch D3's (0 280 155 759)...

Go and get known GENUINE Bosch injectors. Green giants should be OK here. I've had chinese knockoffs get stuck open suddenly and flood the engine completely. Then you try to start, and destroy the...