Just thought i'd update with what ended up happening, removed all the previous drivers installed by the fdci site. Loaded the driver provided through the link here...
Type: Posts; User: rokcrawlin85
Just thought i'd update with what ended up happening, removed all the previous drivers installed by the fdci site. Loaded the driver provided through the link here...
The failed test is with the cable connected to the PC but NOT connected the the vehicle. The short time it clears the test on initial plug in is very odd to me.... could this be a driver issue? I had...
Followed this setup and I have a few questions,
1st- when i setup the tunerpro side of the aldl connection, im only given the option for comm 4, is this normal? Can i only use comm 4 and therefore...
I follow those steps and i get to "updating driver" and my only options for drivers are "Communications port", im not given the 2.08.14 option as a driver :confused:
yes the power led. the receive and transmit leds flash twice then stay off. no i have not installed drivers :rolleye: and im none too computer savvy.... can i get a walk through? maybe?
ok, so i have hooked up the cable as we've discussed, and when i connect it to the laptop it pops up with the typical hardware found blah blah blah, then after about 10 seconds it says the devise is...
That's what I was hoping for. I was just in doubt if I hooked both wires up to the rxd and txd pins if they both could attempt to use the same signal at the same time? Not sure if that's even possible
Ok so I have a question regarding setting this up to be able to read both 160 and 8192 baud rates. Is it possible or am I only able to set it up one way or another? I need the 180 baud rate but...
which would be as simple as adding a toggle switch with the resistor in line between A & B wires....
On a side note.... thank you guys so much for all the knowledge and incite on this site!!! I've...
From everything i've been able to find on here, is that it is nearly identical to the 7747. Just meant for the HD vehicles like 3/4 and 1 ton trucks. I think i can even get away with running the 7747...
Just wanted to check in before i get too excited about this. I know you guys have to be tired of answering a few of us who just can't grasp everything. Anyway, sorry ahead of time, Im using the 8747...