Thanks Robert I'll repin and reset the flag tomorrow morning and see what happens.

sorry I did'nt see your post Robert before I sent My Last

I was able to hook up an occilliscope and establish that its a magnetic vss ac pulse signal 4000 pp/m. so along with reattaching ecm input to pin B10, what else do I need to change.

I will look for some documentation and verify the signal, might take a few days, thank you both for your help so far.

there is actually a stand alone interface with a choice of 8k 4k or 2k and when i mistakenly hooked the digital dash which takes a 8k signal to the 4k terminal the dash speedo read half speed so I...

Tried both floating point and intreger format along with and without deleting the *, still no speedo:mad1:

Here's the adx and xdl file Ive been working with.

I'll have to figure out how to post my xdl, hav'nt done that before.

is switch 18 bit 6 the one you mean, if so it was not set, I set it and tryed it but still no speedo.

In the Scalars list under Vehicle speed Sensor, its set at 4006.96 p/mile. is that what you meant ?

Thanks for the quick responce Robert. I repinned from B10 to C6,and still no data on the adx dash. Do I need to edit the vehicle speed conversion settings in the adx editor, if so can anyone tell me...

Hi everyone, Thanks to this fantastic site I've been able to get my streetrod running quite well,not that it's been easy or that it's finished, but getting closer. I'm using a dakota digital dash...